Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

Chapter —Program Instructions
LBLCOND, cont.
IPL Mode ( = 1)
If the print image is longer than the physical length of the label or ticket,
the print image will extend into the following label(s) until the entire print
image has been printed. Then the media is fed out to the next gap or mark
according to the stop adjust setup. This means that the print image will
not be truncated but may extend into one or more consecutive labels, and
some of the print image may coincide with gaps or slots.
Gap Truncate Mode ( = 2) 3
If the print image is longer than the physical length of the label or ticket,
only the part of the print image that fits on the label or ticket will be printed
and the remainder will be ignored. This means that some of the print
image may not be printed at all, but the following labels will not be affected.
Verifying a start adjust or stop adjust value in the Setup Mode by pressing
key No. 16 (normally labeled “Enter”), or setting the value using a setup
file or setup string, will revoke any LBLCOND statement for the parameter
in question.
The label stop sensor will be returned to normal operation by the statement:
LBLCOND 2,0
All current LBLCOND statements will be revoked at startup or the execution
of a REBOOT statement. This means that the start and stop adjust
will be decided by the setup and the label stop sensor will work normally.
Example In this example, the start adjust value in the setup mode is overridden and
the label stop sensor is set to ignore any gaps in the web within 20 mm
(160 dots at 8 dots/mm; 240 dots at 12 dots/mm) of media feed:
10 LBLCOND 1,5: LBLCOND 2,160
20 FONT "Swiss 721 BT"
30 PRTXT "Hello"
40 PRINTFEED
RUN
1 8 Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual