Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

Chapter —Character Sets and Fonts
Character Sets
The following information applies to all single-byte character sets:
• Characters between ASCII 00 decimal and ASCII 31 decimal are
unprintable control characters as listed below.
• Characters between ASCII 32 decimal and ASCII 127 decimal can
always be printed, regardless of 7-bit or 8-bit communication protocol,
provided that the selected font contains the characters in question.
• Characters between ASCII 128 decimal and ASCII 255 decimal can
only be printed if the selected font contains the characters in question
and an 8-bit communication protocol is used. If you use 7-bit communication,
select another national character set (see NASC statement) or
use a MAP statement to remap a character set.
• If a character, which does not exist in the selected font, is used, an error
condition will occur.
Non-printable control characters (ASCII 00-31 dec)
ASCII Character Meaning
00 NUL Null
01 SOH Start of heading
02 STX Start of text
03 ETX End of text
04 EOT End of transmission
05 ENQ Enquiry
06 ACK Acknowledge
07 BEL Bell
08 BS Backspace
09 HT Horizontal tabulation
10 LF Line feed
11 VT Vertical tabulation
12 FF Form feed
13 CR Carriage Return
14 SO Shift out
15 SI Shift in
16 DLE Data link escape
17 DC1 Device control one
18 DC2 Device control two
19 DC3 Device control three
20 DC4 Device control four
21 NAK Negative acknowledge
22 SYN Syncronous idle
23 ETB End of transmission block
24 CAN Cancel
25 EM End of medium
26 SUB Substitute
27 ESC Escape
28 FS File separator
29 GS Group separator
30 RS Record separator
31 US Unit separator
1 Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual