Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

Chapter —Bar Codes
RSS-14 Expanded Stacked
Separate Instructions
BARTYPE: "RSS14ES"
BARRATIO: Not applicable.
BARMAG: Specifies the x-dimension width in dots of the most narrow element for
both the linear bar code and the 2D code. Default: 2.
BARHEIGHT: Specifies the height of the linear bar code1 . Default: 100.
BARFONT ON/
OFF:
No restriction.
BARSET Instruction
BARSET Instruction
[#] Optionally specifies the start parameter in
the syntax
Bar code type "RSS14ES"
Placeholder Value insignificant.
Placeholder Value insignificant.
Barmag/Enlargement See BARMAG.
Barheight See BARHEIGHT.
Segments per row 2-22 (default 2). Multiples of 2 only.
Placeholder Value insignificant.
Height of separator row The height for the pattern rows between
the linear rows. If too low a height is
entered, the height will be changed to
the smallest legal height for the selected
magnification. Minimum 1X, maximum
2X.
Not applicable
Not applicable
Not applicable
Input Data
No. of characters: Max. 71 numeric or 41 alphanumeric
characters
Allowed characters: 0-9 A-Z a-z ! "
% & ' ( ) * + , - . / : ; < = > ? _ space
FNC1 [CHR$(128)]
1 /. There are restrictions in the standard for the minimum size for each RSS bar code, even if it is possible to print an RSS
bar code in any height. The height should relate to the magnification. RSS Stacked differs, because the bar code rows do
not have the same height. BARHEIGHT or BARSET specifies the height of the lower row and height of the
upper row is automatically calculated from the height of the lower row.
For RSS-14ES, the width is depending on input and the minimum height is 34X per row + 3*1X per separator, where X
is the width of the most narrow element as specified by BARMAG or BARSET.
7 Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual