Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

EAN13 Composite with CC-A or CC-B
Separate Instructions
Chapter —Bar Codes
BARTYPE: "EAN13_CC"
BARRATIO: Not applicable.
BARMAG: Specifies the x-dimension width in dots of the most narrow element for
both the linear bar code and the 2D code. Default: 2. Maximum: 8.
BARHEIGHT: Specifies the height of the linear bar code. Default: 100.
BARFONT ON/
OFF:
BARSET Instruction
ON: The human readable for the linear bar will be printed under the linear
bar code.
If BARSET is set to 1, the human readable for the 2D bar code is
printed too.
OFF: No human readable is printed.
BARSET Instruction
[#] Optionally specifies the start parameter
Bar code type "EAN13_CC"
1 Placeholder Value insignificant. 0 is not allowed.
2 Placeholder Value insignificant. 0 is not allowed.
3 Barmag/Enlargement See BARMAG.
4 Barheight See BARHEIGHT.
5 Placeholder Value insignificant.
Character exclusion in bar code (does not
affect human readables)
Always 1 (default). The bar code and the
human readable field will include exactly
the same data.
7 Height of separator pattern row in dots Value must be 1-2 × BARMAG. For
example, if BARMAG = 5, 5-10 is OK
8 Height of each row in 2D bar code in dots Default: 0 (= 3 × BARMAG)
9 Separator character between data to linear
bar code and 2D bar code
ASCII 2-255 dec. Default: ASCII 124
dec. ASCII 48-57 dec. not allowed.
10 2D human readables On/Off 0 = No human readable 2D field.
1 = Print human readable 2D field.
Input Data
No. of characters: 12
Check digit: 1 Added automatically.
Digits: 0-9
Uppercase letters: No
Lowercase letters: No
Punctuation marks: No
Start characters: No
Stop characters: No
Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual 8