Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

RSS-14 Stacked Omnidirectional
Separate Instructions
Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual
Chapter —Bar Codes
BARTYPE: "RSS14SO"
BARRATIO: Not applicable.
BARMAG: Specifies the x-dimension width in dots of the most narrow element for
both the linear bar code and the 2D code. Default: 2.
BARHEIGHT: Specifies the height of the linear bar code1 . Default: 100.
BARFONT ON/
OFF:
No restriction.
BARSET Instruction
BARSET Instruction
[#] Optionally specifies the start parameter in
the syntax
Bar code type "RSS14SO"
Placeholder Value insignificant.
Placeholder Value insignificant.
Barmag/Enlargement See BARMAG.
Barheight See BARHEIGHT.
Placeholder Value insignificant.
Placeholder Value insignificant.
Height of separator row The height is the same for the pattern
row between the 2D bar code and the
linear bar code as for the pattern rows
between the linear rows. If too low a
height is entered, the height will be changed
to the smallest legal height for the
selected magnification. Minimum 1X,
maximum 2X.
Not applicable
Not applicable
Not applicable
Input Data
No. of characters: 13 digits If less than 13 digits are entered,
leading zeros will automatically be
added so the string will be 13 digits
long.
1 /. There are restrictions in the standard for the minimum size for each RSS bar code, even if it is possible to print an RSS
bar code in any height. The height should relate to the magnification. RSS Stacked differs, because the bar code rows do
not have the same height. BARHEIGHT or BARSET specifies the height of the lower row and height of the
upper row is automatically calculated from the height of the lower row.
For RSS-14SO, the width is 50X and the minimum height is 69X (upper 33X + lower 33X + separator 3*1X min.),