Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

Chapter —Program Instructions
REWINDCONTROL
Purpose Function to control the internal rewind motor in EasyCoder PX-series
printers.
Syntax REWINDCONTROL
Positive values: Specifies for how long the internal rewinder will
pull liner before paper feed motor starts. Maximum value is 5000
dots.
Negative values: Specifies the number of dots the paper will be
fed before the internal rewind motor starts pulling liner. A value
of -1 turns the rewind motor off. Maximum value is label length.
Remarks EasyCoder PX-series printers may have two separate motors, one for feeding
paper and one for rewinding liner. REWINDCONTROL allows for
control of the internal rewind motor. A positive value stretches the liner
before printing to ensure a better dispensing of labels. A positive value
might cause stepper motor to stall for certain liner surfaces. In such cases,
contact your local Intermec support organization. A negative value allows
the label to be rewound with the liner using the self-strip mode. A value
of -1 turns the internal rewind motor off, which makes for more silent
operation when the printer runs without self-strip. This command cannot
be used when REWINDVOID ON is enabled.
Examples REWINDCONTROL 200
REWINDCONTROL -100
0 Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual