Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

SYSVAR, cont.
Chapter —Program Instructions
36: Print changes of program modes (Set or Read)
This parameter is used with the Fingerprint debugger and controls whether
changes of program modes should be printed to the Debug Standard Out
port (see DBSTDIO).
The options are:
0 = Disable printout (default)
1 = Enable printout
37: Set Minimum Gap Length (Set or Read)
The media may have perforations or marks that not are intended to be
interpreted as gaps or black marks by the LSS. Using this SYSVAR parameters,
it is possible to make the LSS ignore gaps or marks that are shorter
that a specified value. (In this context, long and short are related to
the media feed direction.) The minimum gap length is specified in dots
within a range of 1-32. Default value is 1 mm (0.039 inches). Note that
SYSVAR(37) affects PRINTFEED and FORMFEED. For TESTFEED,
see SYSVAR(38).
38: Set Equal Safe for TESTFEED
This parameter is obsolete and has no effect, even if it does not cause an
error if used.
39: Enable/Disable Slack Compensation-Force Startadjust (Set or Read)
Slack compensation:
Label slack compensation is a method of eliminating slack in the belts
after having fed the media back. At a negative FORMFEED, the printer
will pull back the media slightly more than specified by the FORMFEED
statement and then feed the media forward the same distance. If slack
compensation is enabled, and FORMFEED -100 is specified, the printer
will pull back the media for example -112 dots and then feed the media
forward +12 dots to take out the slack.
Force Startadjust:
Performing a positive FORMFEED will normally only feed out paper
even if startadjust is set to a negative value. Using narrow labels and liner
rewinding may cause the printout position to differ on the next printed
label after a FORMFEED. Forcing a startadjust when doing FORMFEED
improves printout precision in such cases.
The options are:
0 = Disable slack compensation and disable force startadjust.
1 = Enable slack compensation (default).
2 = Force startadjust at FORMFEED.
3 = Force startadjust at FORMFEED and enable slack compensation.
40: Not Implemented
41: “Next label not found” at Predefined Feed Length (Set or Read)
The automatic detection of the error condition “Next label not found”
(error 1031) by the label stop sensor can be overridden by specifying a
Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual 7