Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

BARFONT (BF)
Chapter —Program Instructions
Purpose Statement specifying fonts for the printing of bar code interpretation.
Syntax BARFONT|BF[#,][,[,[,
[, [,[,[,[,[,
]]]]]]]]][ON]
# is, optionally, the start parameter in the syntax above.
is the name of the font selected for bar code interpretations.
is the height in points of the font.
is the clockwise slant in degrees (0-90°).
is the distance in dots between bar code and bar font.
is the magnification in regard of height (1-4).
is the magnification in regard of width (1-4).
is the width enlargement in percent relative the height (1-1000).
Default: 100. Does not work with bitmap fonts.
is the insertion point for the bar code interpretation.
is the horizontal offset from the insertion point for the bar code
interpretation.
is the vertical offset from the insertion point for the bar code
interpretation.
ON optionally enables the printing of bar code interpretation.
Reset to default by: PRINTFEED execution.
Remarks Start Parameter:
The start parameter specifies which parameter in the syntax above should
be the first parameter in the statement. Thereby you may bypass some of
the initial parameters.
Default value: #1
Font Name:
This parameter corresponds to the FONT statement, but will only affect
bar code interpretation. Double-byte fonts cannot be used.
Default : Swiss 721 BT
Font Size:
This parameter corresponds to the FONT statement, but will only affect
bar code interpretation. The size is specified in points. (1 point = 1/72 inch
≈ 0.352 mm.)
Default : 12
Font Slant:
This parameter corresponds to the FONT statement, but will only affect
bar code interpretation. Slanting increases clockwise. Values greater that
65-70° will be unreadable.
Default : 0
Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual 17