Bid #01-1112 Library and Reprographics Roofing ... - Citrus College

More documents

Recommendations

Info

D. Acceptable Contractor: Contractor shall have a minimum of 2 years experience in successfully installing the same or similar roofing materials and be certified in writing by the roofing materials manufacturer to install the primary roofing products. E. Scope of Work: The work to be performed under this specification shall include but is not limited to the following: Attend necessary job meetings and furnish competent and full time supervision, experienced roof mechanics, all materials, tools, and equipment necessary to complete, in an acceptable manner, the roof installation in accordance with this specification. Comply with the latest written application instructions of the manufacturer of the primary roofing products. In addition, application practice shall comply with requirements and recommendations contained in the latest edition of the Handbook of Accepted Roofing Knowledge (HARK) as published by the National Roofing Contractor's Association, amended to include the acceptance of a phased roof system installation. F. Local Regulations: Conform to regulations of public agencies, including any specific requirements of the city and/or state of jurisdiction. G. Manufacturer Requirements: Ensure that the primary roofing materials manufacturer provides direct trained company personnel to attend necessary job meetings, perform periodic inspections as necessary, and conducts a final inspection upon successful completion of the project. 1.05 GUARANTEE/WARRANTY A. Roof Membrane Guarantee (Library Lower Roof and Reprographics): Upon successful completion of the project, and after all post installation procedures have been completed, furnish the Owner with the manufacturer's ten year labor and materials membrane guarantee. The guarantee shall be a term type, without deductibles or limitations on coverage amount, and shall be issued at no additional cost to the Owner. This guarantee shall not exclude random areas of ponding from coverage. > Siplast ten year Roof Membrane Guarantee B. Roof Membrane Guarantee (Library - Mechanical Well): Upon successful completion of the project, and after all post installation procedures have been completed, furnish the Owner with the manufacturer's ten year labor and materials membrane guarantee. The guarantee shall be a term type, without deductibles or limitations on coverage amount, and shall be issued at no additional cost to the Owner. This guarantee shall not exclude random areas of ponding from coverage. > Siplast Parapro 10 year Roof Membrane Guarantee 1.06 SUBSTITUTIONS A. Substitutions: Per Public Contract Code Section 3400, the School District has standardized the choice of roofing throughout the District and has established the specified product(s) as a “District Standard” item. Therefore, NO ROOFING SUBSTITUTIONS will be considered. 1.07 SUBMITTALS M-13-135 page - 6 Citrus Library Roofing Specification
All submittals which do not conform to the following requirements will be rejected. A. Submittals Prior to Contract Award: 1. Letter from the proposed primary roofing manufacturer confirming that the bidder is an acceptable Contractor authorized to install the proposed system. 2. Letter from the primary roofing manufacturer stating that the proposed application will comply with the manufacturer's requirements in order to qualify the project for the specified guarantee. B. Submittals Prior to Project Close-out: 1. Certificate Of Analysis from the testing laboratory of the primary roofing materials manufacturer, confirming the physical and mechanical properties of the roofing membrane components. Testing shall be in accordance with the parameters published in ASTM D 5147 and ASTM D 7051 and indicate Quality Assurance/Quality Control data as required to meet the specified properties. A separate Certificate Of Analysis for each production run of material shall indicate the following information: a) Material type b) Lot number c) Production date d) Dimensions and Mass (indicate the lowest values recorded during the production run); - Roll length - Roll width - Selvage width - Total thickness - Thickness at selvage (coating thickness) - Weight e) Physical and Mechanical Properties; - Low temperature flexibility - Peak load - Ultimate Elongation - Dimensional stability - Compound Stability - Granule embedment - Resistance to thermal shock (foil faced products) 2. Manufacturer's printed recommendations for proper maintenance of the specified roof system including inspection frequencies, penetration addition policies, temporary repairs, and leak call procedures. 1.08 PRODUCT DELIVERY STORAGE AND HANDLING A. Delivery: Deliver materials in the manufacturer's original sealed and labeled containers and in quantities required to allow continuity of application. B. Storage: Store materials out of direct exposure to the elements on pallets placed over clean, flat and dry surfaces. Storage of pallets over dirt, grass-covered ground or newly placed concrete may result in upward moisture transpiration and contamination of product. Store rolls of roofing on end. For roof-top storage, avoid overloading of deck and building M-13-135 page - 7 Citrus Library Roofing Specification
Page 1 and 2:
Bid #01-1112 Library and Reprograph
Page 3 and 4:
NOTICE TO CONTRACTORS CALLING FOR B
Page 5 and 6:
Preparation and Submittal of Bid Pr
Page 7 and 8:
District's Right to Modify Contract
Page 9 and 10:
Job-Walk Proposals must be held ope
Page 11 and 12:
documents submitted in response to
Page 13 and 14:
Purchasing Office located at 1000 W
Page 15 and 16:
acknowledges that the District may,
Page 17 and 18:
SUBCONTRACTORS LIST Bidder: _______
Page 19 and 20:
___________________________________
Page 21 and 22:
5.1.2 Are there any judgments, orde
Page 23 and 24:
Executed this ________ day of _____
Page 25 and 26:
IN WITNESS WHEREOF, the Principal a
Page 27 and 28:
AGREEMENT THIS AGREEMENT is made th
Page 29 and 30:
LABOR AND MATERIAL PAYMENT BOND KNO
Page 31 and 32:
PERFORMANCE BOND KNOW ALL MEN BY TH
Page 33 and 34:
CERTIFICATE OF WORKERS' COMPENSATIO
Page 35 and 36:
5. Contractor and I acknowledge tha
Page 37 and 38:
The undersigned individual executin
Page 39 and 40:
6.1 Workers' Compensation Insurance
Page 41 and 42:
GENERAL CONDITIONS ARTICLE 1: DEFIN
Page 43 and 44:
equipment or workmanship forming a
Page 45 and 46:
3.1.4 Verification of Applications
Page 47 and 48:
actual or potential impact of any s
Page 49 and 50:
coordination of the Work and compon
Page 51 and 52:
superintendent shall represent the
Page 53 and 54:
Contract Time or the Contract Price
Page 55 and 56:
4.10 Safety limitation, orders for
Page 57 and 58:
4.11.5 Compliance with Proposition
Page 59 and 60:
4.21.2 Payment of Prevailing Rates.
Page 61 and 62:
eight (8) hours in any calendar day
Page 63 and 64:
that such person hold a valid contr
Page 65 and 66:
performed, whether such operations
Page 67 and 68:
6.8 Indemnity. Unless arising solel
Page 69 and 70:
7.3.1 Submittal of Preliminary Cons
Page 71 and 72:
hereinabove. The District's electio
Page 73 and 74:
or Final Completion, the Work is ac
Page 75 and 76:
Payment pursuant to the preceding s
Page 77 and 78:
following, the submittal of which a
Page 79 and 80:
(xxi) Failure to properly pay preva
Page 81 and 82: failure, for any reason, to give wr
Page 83 and 84: shall constitute full compensation
Page 85 and 86: with the performance of such item o
Page 87 and 88: tests, inspections or approvals rev
Page 89 and 90: of the Contractor under the Contrac
Page 91 and 92: 15.1.7 Conversion to Termination fo
Page 93 and 94: SPECIAL CONDITIONS 1. Application o
Page 95 and 96: REQUEST FOR SUBSTITUTION FORM Failu
Page 97 and 98: CERTIFICATION OF EQUAL PERFORMANCE
Page 99 and 100: W-9 Form (Rev. October 2007) Depart
Page 101 and 102: Form W-9 (Rev. 10-2007) Generally,
Page 103 and 104: Citrus College Citrus Community Col
Page 105 and 106: Roofing Specification For: Citrus C
Page 107 and 108: The basic work descriptions (compon
Page 109 and 110: 7. Duct systems shall not be pressu
Page 111 and 112: 1. Letter from the proposed primary
Page 113 and 114: 3. Limited Access: Prevent access b
Page 115 and 116: 2. Self-Adhesive Modified Bitumen F
Page 117 and 118: 1. Insulation Fasteners: Insulation
Page 119 and 120: metal edge fascia with 1 foot secti
Page 121 and 122: fastening should be provided at all
Page 123 and 124: ase ply surface and up the primed w
Page 125 and 126: C. Lead Pipe Flashings: Completely
Page 127 and 128: Roofing Specification For: Citrus C
Page 129 and 130: Library - Lower Roof Area Project T
Page 131: 6. All penetrations into ducts shal
Page 135 and 136: designated crew member shall watch
Page 137 and 138: Paradiene 20 TG P, by Siplast; Irvi
Page 139 and 140: 1. Insulation Fasteners: Insulation
Page 141 and 142: Fabricate metal edge/fascia in maxi
Page 143 and 144: ASTM A 792. Steel decks should be s
Page 145 and 146: een applied to the top of the cant,
Page 147 and 148: (1) foot in either direction from t
show all

Bid #01-1112 Library and Reprographics Roofing ... - Citrus College

Create successful ePaper yourself

Delete template?

Save as template?