Product Manual

DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a
frame the Switch will examine, such as the MAC source address or the IP destination address. The
second part is entering the criteria the Switch will use to determine what to do with the frame.
To display the currently configured Access Profiles on the Switch, open the Configuration folder and
click on the Access Profile Table link. This will open the Access Profile Table window, as shown
below.
Figure 6- 53. Access Profile Table window
To add an entry to the Access Profile Table, click the Add button. This will open the Access Profile
Configuration window, as shown below. There are three Access Profile Configuration windows;
one for Ethernet (or MAC address-based) profile configuration, one for IP address-based profile configuration
and one for the Packet Content Mask. You can switch between the three Access Profile
Configuration windows by using the Type drop-down menu. The window shown below is the Access
Profile Configuration window for Ethernet.
Note: Up to 9 Access Profiles may be created for the Switch. The Profile ID is used
for relative priority for an Access Profile should a conflict arise between a rule
created in one profile and a rule created in a different profile. Please read the CLI
Reference Manual chapter discussing Access Control List (ACL) Commands.
85