Trend Micro InterScan Gateway Security Appliance M-Series ...

Technology Reference
Enabling or Disabling LAN Bypass and Link
State Failover
Accessing the Preconfiguration Console
Follow the procedures below to access the appliance Preconfiguration console.
To access the preconfiguration console:
1. Connect one end of the included console cable to the CONSOLE port on the
back panel of the device and the other end to the serial port (COM1, COM2, or
any other available COM port) on a computer. (See Figure 15-1, “Back panel of
appliance showing console port, management port, and INT port,” on page 8.)
Tip: Trend Micro recommends that you configure HyperTerminal properties
so that the backspace key is set to delete and that you set the emulation
type to VT100J for best display results.
2. Open HyperTerminal (Start > Programs > Accessories > Communications >
HyperTerminal). For best display results, set the terminal emulation to
VT100J, as shown below.
FIGURE C-1. HyperTerminal display settings
C-5