Installation & Operation Manual - StellarSupport - John Deere
Installation & Operation Manual - StellarSupport - John Deere
Installation & Operation Manual - StellarSupport - John Deere
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Virtual Terminal Calibration<br />
Calibration<br />
Once installation of the injection system has been verified, and the motor control node is recognized by the<br />
ISOBUS VT control console, the Sidekick Pro ISO and VT display must be calibrated to provide accurate<br />
control of the injected product.<br />
The following settings must be calibrated or programmed to ensure proper control and operation of each<br />
injection pump:<br />
Note: These settings must be programmed for each injection product or pump which will be used to<br />
control product during an application. Refer to the specific control console manual for instructions<br />
on programming these settings or other calibration information on the console.<br />
To access the Raven Product Control screen and begin calibrating the Sidekick Pro ISO injection pump:<br />
1. Select the VT display menu.<br />
Raven ISOBUS Interface Screen Required Settings<br />
Product Information<br />
Product Home Screen<br />
Product Setup Screen<br />
Alarm Setup Screen<br />
Pump Number (see the Detecting and Addressing<br />
the Motor Control Node section on page 29)<br />
Pump Mode section on page 32<br />
Rate Cal (Target) section on page 33<br />
Tank Volume section on page 33<br />
Pump Size section on page 34<br />
Meter Cal section on page 34<br />
Valve Cal section on page 35<br />
Valve Cal 2 section on page 35<br />
Direct Injection (DI) Tank Capacity section on<br />
page 35<br />
Pressure Cal section on page 36<br />
Rate Bump (±) section on page 36<br />
Display Smoothing section on page 37<br />
Zero Speed Shutoff section on page 37<br />
Agitator Enable section on page 37<br />
Ratio Rate Enable section on page 37<br />
Low Tank section on page 38<br />
Off Rate section on page 38<br />
FER Cal section on page 38<br />
Low Limit section on page 39<br />
<strong>Manual</strong> No. 016-0171-509 Rev. B 31<br />
4