Installation & Operation Manual - StellarSupport - John Deere

Display Smoothing
Calibration
Toggle the display smoothing feature to smooth the rate displayed on the product control home screen. With
the feature enabled, as long as the actual rate is within 10% of the actual application rate, the target rate will
display as the actual rate on the display. The actual rate will be displayed if the actual rate does not reach the
target rate dead band (+/-3%) within 10 seconds.
Zero Speed Shutoff
The zero speed feature will automatically turn off product application if the vehicle speed drops below 0.7 mph
[1.1 km/h] while in automatic mode. To restart the system, cycle the master switch ‘Off’ then back ‘On.’ A speed
of 0.7 mph [1.1 km/h] must be maintained for more than 10 seconds or the zero speed feature will reactivate.
Agitator Enable
If equipped with an injection system featuring an agitator enabled output, this option enables or disables a
chemical agitator.
Ratio Rate Enable
The ratio rate feature configures the selected control channel to apply an injected chemical at a rate
proportional to the carrier product flow rate. The ratio rate application mode must be enabled via the control
console and a ratio rate cal value must be entered for each product controlled in ratio to the carrier.
Note: If the off rate alarm is triggered frequently during injection applications in ratio rate mode, access
the volume per minute display on the control console and verify that the target flow rate is within
the application range for the pump.
The ratio rate calibration value is entered as the ratio of injected chemical to carrier in ounces per gallon
[deciliters per liter].
Alarms Setup Screen Calibration Settings
In addition to the product control capabilities of the Raven ISOBUS product control system, the ISOBUS
communication protocol offers excellent error detection capabilities, making it very suitable and reliable for
agricultural applications. To access the Alarm Setup screen:
Manual No. 016-0171-509 Rev. B 37
4