Installation & Operation Manual - StellarSupport - John Deere
Installation & Operation Manual - StellarSupport - John Deere
Installation & Operation Manual - StellarSupport - John Deere
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Operation</strong><br />
The Product Control Home screen may be used to monitor operation of each Sidekick Pro ISO direct injection<br />
pump connected to the ISOBUS system. The following sections offer a brief description of the information<br />
displayed on the Product Control Home screen during field operations.<br />
Speed Display<br />
The speed reported over the ISOBUS is displayed on the Product Control Home screen for reference. If the<br />
pump mode is set to automatic during field operations, the Sidekick Pro ISO will automatically adjust the<br />
chemical injection rate for changes in vehicle speed.<br />
Note: The Product Control Home screen displays the current flow rate for the selected pump in the<br />
lower, left corner of the VT display for reference during field operations.<br />
If the speed display is not registering actual vehicle speed properly, the product control and injection system<br />
may not be applying the correct amount of product during field operations. Troubleshoot the speed sensor as<br />
necessary.<br />
Carrier and Injection Pressure Displays<br />
The Product Control Home screen displays the carrier and injected chemical pressure for the selected injection<br />
pump for reference during field operations. The injection pressure is monitored at the pump outlet port.<br />
Section Status Display<br />
The status of sections configured with the ISO product control system is displayed on the injection Product<br />
Control Home screen for reference. If the pump mode is set to automatic during field operations, the Sidekick<br />
Pro ISO will automatically adjust the chemical injection rate for active sections.<br />
Note: The Product Control Home screen displays the calculated width of active sections in the lower, left<br />
corner of the VT display for reference during field operations.<br />
Soft Keys<br />
Master Switch. Select this icon to toggle the injection pump on or off.<br />
Rate ± (Increase/Decrease). Use the rate increase and decrease buttons to adjust the target application rate<br />
in automatic control mode. When selected in manual mode, the rate increase or decrease buttons adjust the<br />
actual rate of injection.<br />
Refer to the Rate Cal (Target) section on page 33 to set the rate bump value.<br />
Tools. Select the Tools icon to access the Calibration screens. Refer to the following sections for more<br />
information on the calibration screens:<br />
Calibration<br />
Screen Tab<br />
Section<br />
Product Diagnostics Screen section on page 51<br />
Product Setup Screen Calibration Settings section on page 34<br />
<strong>Manual</strong> No. 016-0171-509 Rev. B 47<br />
5