Prisma II 1310 nm High Density Transmitter and Host Module ...
Prisma II 1310 nm High Density Transmitter and Host Module ...
Prisma II 1310 nm High Density Transmitter and Host Module ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix A<br />
<strong>Module</strong> Parameter Descriptions<br />
<strong>High</strong> <strong>Density</strong> <strong>Transmitter</strong> Parameters<br />
Operating Status Parameters<br />
Parameter<br />
Name (LCI)<br />
Optical Output<br />
Power<br />
Laser Bias<br />
Current<br />
RF Input<br />
Power<br />
<strong>Module</strong><br />
Temperature<br />
ICIM<br />
Abbreviation<br />
Function<br />
Typical<br />
Value<br />
OutPwr Displays optical output power 8.2 dBm<br />
LasBias Displays laser bias current 123 mA<br />
InRF Displays RF input level -11.5 dB<br />
ModTemp Displays module temperature 54.3 °C<br />
TEC Current TecCur Displays laser thermoelectric cooler<br />
current<br />
Laser<br />
Temperature<br />
-225 mA<br />
LasTemp Displays laser temperature 25.5 °C<br />
Laser RF Drive LasRF RF drive level at laser input reference to<br />
nominal setup<br />
Laser Enable Enable Laser on/off -<br />
CwMode CwMode Continuous wave mode operation -<br />
Low RF Alarm<br />
Inhibit<br />
LoRFInh Low RF alarm enabled/disabled -<br />
Master Master Master or Slave operation -<br />
RF Drive Level RFDrive RF drive level reference to nominal<br />
setup. Only effective when AGC is off<br />
(manual gain control).<br />
AGC AGC Automatic Gain Control -<br />
OMI Level<br />
Setting<br />
OMISet<br />
Optical Modulation Index level offset.<br />
Only effective when AGC is on.<br />
-3.890 dB<br />
0.0 dB<br />
0.0 dB<br />
Note: Monitored values may vary from module to module. The values shown above<br />
are examples only.<br />
104 78-4021716-01 Rev C
Change language