Prisma II 1310 nm High Density Transmitter and Host Module ...
Prisma II 1310 nm High Density Transmitter and Host Module ...
Prisma II 1310 nm High Density Transmitter and Host Module ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SNMP Configuration<br />
To Restart the ICIM by Removing the ICIM<br />
1 Unscrew the captive screw near the top right-h<strong>and</strong> corner of the ICIM.<br />
2 Unlock the top <strong>and</strong> bottom ejector levers near the left-h<strong>and</strong> side of the ICIM.<br />
3 Pull the ejector levers out <strong>and</strong> away from the front panel to disconnect the ICIM<br />
from the chassis backplane connector.<br />
4 Pull the ICIM at least 1.5 inches (3.81 cm) out from the front of the chassis to<br />
ensure that it is fully separated from the chassis backplane connector.<br />
5 Reinsert the ICIM into the chassis until the ejector levers insert into their<br />
respective slots in the chassis.<br />
6 Push the ejector levers in <strong>and</strong> flat against the ICIM front panel to reconnect the<br />
ICIM to the backplane connector until the ejector levers lock in place.<br />
7 Screw in the captive screw to secure the ICIM in the chassis.<br />
78-4021716-01 Rev C 63