Prisma II 1310 nm High Density Transmitter and Host Module ...

High Density Transmitter Parameters
Configurable Parameters
Parameter
Name (LCI)
ICIM
Abbreviation
Description Values Default
Laser Enable Enable Enables or disables amplifier
operation, i.e., turns the laser on or
off.
Cw Mode CwMode Automatically adjusts the
displayed RF input level by
subtracting 3 dB when CW mode
is on. The RF high alarm is also
disabled when CW mode is on.
Low RF Alarm
Inhibit
LoRFInh
Enables or disables the "RF input
low" alarm.
Master Master Configures the module as master
or slave:
• If set to Master, the transmitter
is controlled only by the
Enable control above.
ON (1) = Enabled
OFF (0) =
Disabled
ON (1) = Enabled
OFF (0) =
Disabled
ON (1) = Alarm
Enabled
OFF (0) = Alarm
Disabled
ON (1) = Master
OFF (0) = Slave
ON (1)
OFF (0)
ON (1)
ON (1)
• If set to Slave, the transmitter
is controlled by a combination
of Enable and the external
input CNT_IN_1.
RF Drive Level RFDrive Sets the relative RF drive level into
the transmitter. Only effective
when AGC is off (manual gain
control).
Automatic Gain
Control
OMI Level
Setting
AGC
OMISet
Turns automatic gain control on or
off.
Adjust the offset of optical
modulation index level. Only
effective when AGC is on.
-5.0 dB to +3.0 dB
in 0.5 dB steps
ON (1)
OFF (0)
-8.0 dB to +2.0 dB
in 0.5 dB steps
0.0 dB
OFF (0)
0.0 dB
78-4021716-01 Rev C 105