20.05.2014 Views

Peterbilt Medium Duty Trucks Operator's Manual after 1-07

Peterbilt Medium Duty Trucks Operator's Manual after 1-07

Peterbilt Medium Duty Trucks Operator's Manual after 1-07

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Shut–Down<br />

3. Drain water from the air reservoirs.<br />

• While the engine and air supply system are still<br />

warm, drain moisture from the air reservoirs. Open<br />

the reservoir drains just enough to drain the moisture.<br />

Do not deplete the entire air supply. Be sure to<br />

close the drains before leaving the vehicle.<br />

4. Secure the vehicle, close all the windows, and lock all<br />

doors.<br />

Before Stopping the Engine<br />

Do not shut off the engine immediately. A hot engine stores a<br />

great amount of heat and it does not cool down immediately<br />

<strong>after</strong> you shut if off. Always cool the engine down before shutting<br />

it off. You will greatly increase its service life.<br />

Idle the engine at 1000 rpm for five minutes. Then low idle for<br />

thirty seconds before shutdown. This will allow circulating<br />

coolant and lubricating oil to carry away heat from the cylinder<br />

head, valves, pistons, cylinder liners, turbocharger, and<br />

bearings. This way you can prevent engine damage that may<br />

result from uneven cooling.<br />

Turbocharger<br />

Operating Instructions<br />

This cooling-down practice is especially important for a turbocharged<br />

engine. The turbocharger on your vehicle contains<br />

bearings and seals that are subjected to hot exhaust gases.<br />

While the engine is operating, heat is carried away by circulating<br />

oil. If you stop the engine suddenly <strong>after</strong> a hard run, the<br />

temperature of the turbocharger could rise to as much as<br />

100°F (55°C) above the temperature reached during operation.<br />

A sudden rise in temperature like this could cause the<br />

bearings to seize or the oil seals to loosen.<br />

Refueling<br />

Air inside the fuel tanks allows water to condense in the tank.<br />

To prevent this condensation while the vehicle is parked for<br />

extended periods of time, fill the tanks to 95 percent of<br />

capacity. Never fill to more than 95 percent capacity as this<br />

provides room for expansion resulting from temperature<br />

extremes. When refueling, add approximately the same<br />

amount to each fuel tank on vehicles with more than one<br />

tank.<br />

– 114 – Y53-6008 <strong>Medium</strong> <strong>Duty</strong> (R10/06)

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!