Peterbilt Medium Duty Trucks Operator's Manual after 1-07
Peterbilt Medium Duty Trucks Operator's Manual after 1-07
Peterbilt Medium Duty Trucks Operator's Manual after 1-07
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Electrical System<br />
Slow Battery Charging<br />
NOTE: Follow the instructions that come with your<br />
battery charger.<br />
• It is not necessary to remove the battery from the compartment.<br />
WARNING! Charger cables must be connected<br />
positive to positive (+ to +) and negative to negative<br />
(– to –). If connected improperly, batteries<br />
could explode causing serious personal injury.<br />
Bulb Replacement<br />
Tail Lights<br />
Preventive Maintenance<br />
To replace the tail lamps, remove lens. The bulbs are all of<br />
the bayonet type.<br />
1. To remove the bulbs, turn bayonet counter clockwise and<br />
pull out.<br />
2. To install, fit the bulb in the socket, push in and turn bayonet<br />
clockwise.<br />
• Always make sure the battery charger is OFF before<br />
connecting or disconnecting the cable clamps. To<br />
reduce the danger of explosions and resulting serious<br />
personal injury, do not connect or disconnect<br />
charger cables while the charger is operating.<br />
1. Make sure the electrolyte level in each cell is between<br />
the “MIN” and “MAX” marks. If the fluid level is below the<br />
“MIN” mark, correct the condition.<br />
2. Disconnect the battery cables.<br />
3. Connect charger cables.<br />
4. Start charging the battery at a rate not over 6 amperes.<br />
Normally, a battery should be charged at no more than<br />
10 percent of its rated capacity.<br />
5. After charging, turn OFF charger and disconnect charger<br />
cables.<br />
Replacement Bulbs<br />
DESCRIPTION<br />
Headlights<br />
Front turn signal<br />
Marker<br />
Stop/tail turn<br />
Backup<br />
Hood marker<br />
Roof marker<br />
Dome<br />
Warning lamp module<br />
PART NO.<br />
90<strong>07</strong>BULB<br />
3157K LL BULB<br />
1895BULB<br />
1157BULB<br />
1156BULB<br />
4157NAK LL BULB<br />
194BULB<br />
1141BULB<br />
#37 or 73 (T1 3/4 wedge<br />
base<br />
– 190 – Y53-6008 <strong>Medium</strong> <strong>Duty</strong> (R10/06)