Peterbilt Medium Duty Trucks Operator's Manual after 1-07
Peterbilt Medium Duty Trucks Operator's Manual after 1-07
Peterbilt Medium Duty Trucks Operator's Manual after 1-07
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Engine Maintenance<br />
Fuel System<br />
Specification: Use only Diesel Fuel, Grade 2-D, as recommended<br />
by engine manufacturers. If you need further information<br />
on Grade 2-D fuel specifications, consult the Engine<br />
Operation <strong>Manual</strong> in the glove compartment.<br />
WARNING! Diesel fuel in the presence of an ignition<br />
source (such as a cigarette) could cause an<br />
explosion. You could be seriously injured. A<br />
mixture of gasoline or alcohol with diesel fuel<br />
increases this risk of explosion.<br />
CAUTION: If anyone ever pours gasoline into<br />
your fuel tank, drain the entire system. Otherwise,<br />
the pump and engine will be damaged.<br />
Don't try to dilute the gasoline by adding diesel<br />
fuel (see Warning above).<br />
Preventive Maintenance<br />
Please follow these recommendations when you are changing<br />
your fuel filters or strainer elements. Your vehicle's engine<br />
will run better and last longer if you do. See the engine manufacturer's<br />
recommendations for proper water and micron<br />
requirements.<br />
Installing Fuel Filters<br />
When removing filters, cover any electrical equipment and<br />
wiring that might get soaked with fuel. Diesel fuel may permanently<br />
damage electrical insulation.<br />
When installing spin–on (throwaway) filters:<br />
1. Prefill filter with fuel.<br />
2. Moisten gasket with diesel fuel.<br />
3. Hand tighten them only 1/2 to 2/3 turn <strong>after</strong> gasket contact.<br />
Mechanical tightening of these filters may distort or<br />
crack the filter head.<br />
• When replacing a fuel filter element, do not use a substitute.<br />
Install only filter elements designed for fuel filtration.<br />
First clean and inspect the shell. Then insert the new<br />
element and fill the container at least 2/3 full of clean fuel<br />
before installing the shell<br />
– 140 – Y53-6008 <strong>Medium</strong> <strong>Duty</strong> (R10/06)