Learning by Doing: CISCO Certified Network ... - SCN Research

Other modes you may use include: controller, map-list, route-map, ipx router and
map-class. Use your knowledge of help commands to figure out what those
prompts would look like.
Supplemental Labs or Challenge Activity:
1. Try going through the initial configuration setup (put in yes instead of no). See
how it differs. Its actually very nice but don’t get too attached to it. You will
learn more by configuring your router using the command line interface (CLI).
2. What are the other options available with the copy command?
3. If your router is already started then how would you get the router setup script
back?
So What Have I Learned Here?
In this lab you learned basic router steps including getting help. I guarantee you will be
using the help function many more times during your training. In the next lab we will
look a bit deeper into how the router boots. I actually had a lot of fun writing that
one…there is some information in there you won’t find in any books or documentation
anywhere.
User Mode ? Options
Command Description
166