Learning by Doing: CISCO Certified Network ... - SCN Research

05:04:35: BR0/0:2 DDR: disconnecting call
05:04:36: BR0/0 DDR: Dialing cause ip (s=192.168.1.2, d=192.168.1.1)
05:04:36: BR0/0 DDR: Attempting to dial 5551234
kissane#
kissane#debug ppp nego
PPP protocol negotiation debugging is on
kissane#ping 192.168.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:.....
Success rate is 0 percent (0/5)
kissane#
05:14:06: BR0/0:1 LCP: State is Closed
05:14:06: BR0/0:1 PPP: Phase is DOWN
05:14:06: BR0/0:2 LCP: State is Closed
05:14:06: BR0/0:2 PPP: Phase is DOWN
kissane#
Obviously to fix this we just plug that cable in to the BRI interface.
No dialer list (layer 2):
For this one I just removed the dialer map statement.
kissane#sh isdn status
Global ISDN Switchtype = basic-ni
ISDN BRI0/0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 64,Ces = 1,SAPI = 0,State =MULTIPLE_FRAME_ESTABLISHED
Spid Status:
TEI 64,ces = 1,state = 5(init)
spid1 configured, spid1 sent, spid1 valid
Endpoint ID Info: epsf = 0, usid = 70, tid = 1
TEI Not Assigned, ces = 2, state = 1(terminal down)
spid2 configured, spid2 NOT sent, spid2 NOT valid
Layer 3 Status:
0 Active Layer 3 Call(s)
Activated dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Total Allocated ISDN CCBs = 0
Layer 1 is active (normal), only 1 TEI on layer 2 (abnormal), and nothing on layer 3
(abnormal). We still need some more information.
435