Learning by Doing: CISCO Certified Network ... - SCN Research

Shadow
16 17
18 18
Diekman 17 16 Knight
understand if you add the dlci connection (in this case to our Adtran) within a
table format. Start by putting “none” in the sub-interface configuration space
(notice the format s0/0.16 for dlci #16) for the dlci to which the serial line
connects (Use the first drawing not the one above…it can be confusing):
Router Diekman Shadow Knight
S0/0 none none none
Adtran 1/1 1/2 2/1
Dlci 16 18 17
S0/0.16 none
S0/0.17
none
S0/0.18
none
Next, add in the ip address for the subnet/sub-interface… Let’s start with circuit
#1 (192.168.1.0 network using .1 and .2):
Router Diekman Shadow Knight
S0/0 none none none
Adtran 1/1 1/2 2/1
Dlci 16 18 17
S0/0.16 none 192.168.1.2
S0/0.17
none
S0/0.18 192.168.1.1 none
See? Our circuit #1 has a connection on dlci #18 on Diekman and dlci #16 on
Shadow. Since we are using the 192.168.1.0 network we arbitrarily pick which
one has which address. We will be using the sub-interface number that
corresponds with the dlci number. We don’t have too it is just easier that way.
401