Learning by Doing: CISCO Certified Network ... - SCN Research

Gateway Tab
Figure 4—Putting in an IP address and mask.
5. Next we need to switch to the gateway tab (see figure 4) and put in the gateway
address. We would type it in and click “add.” Your pop up window will look
like this:
Figure 5—Adding a gateway.
6. Almost done. To finish it up we click on “ok” on the TCP/IP Properties window,
and then “OK” in the network window. You should then be prompted to reboot
your computer to make the settings take effect. If you do not reboot then they
will not work properly.
7. You can double-check your settings using those DOS or windows commands
“IPCONFIG.EXE” or “WINIPCFG.EXE.”
24