Learning by Doing: CISCO Certified Network ... - SCN Research

5. Wait two minutes. Remember, you won’t see them until you stop the capture and
analyze what has happened.
6. End the capture on the protocol inspector by pressing “stop.”
7. Open the capture file.
8. From workstation A you should see something like these pictures (results will
vary somewhat):
Figure 3—Here we can see what we were expecting…RIP and ICMP. And those
STP packets? You will learn about them in part 3.
Figure 4—We can even look down to the HEX information (bit-by-bit) at our RIP
update captures. Notice how our RIP Operation is a “broadcast” (FF FF FF FF FF
FF) on the network.
205