audio file in the INSERT mode - Fostex

• Showing the router IP address
1. Select "Gateway?" and press the [SKIP/CURSOR]
>>| key.
The current IP address is shown (the default is 192.
168. 1 . 1).
Pressing the [||] key alternates the following
screens.
SETUP
• Showing the subnet mask
1. Select "Sub net?" and press the [SKIP/CURSOR]
>>| key.
The current subnet mask is shown (the default is 0. 0.
0. 0).
Pressing the [||] key alternates the following
screens.
SETUP
Flashing
Flashing
SETUP
SETUP
• Setting the router IP address
1. While either of the screen above is shown, press
the [ENTER/YES] key.
The leftmost three-digit value of the current IP address
starts flashing, showing that you can now edit it.
• Setting the subnet mask
1. While either of the screen above is shown, press
the [ENTER/YES] key.
The leftmost value of the current subnet mask starts
flashing, showing that you can now edit it.
SETUP
SETUP
Flashing
2. Use the [||] keys to move the flashing
(editing) point and use the jog dial or numeric keys
to enter a desired value.
3. After entering the desired value, press the
[ENTER/YES] key.
"Wait!" is shown for a while, and the new IP address is
set.
4. To exit the Setup mode, press the [EXIT/NO] key
or [STOP] key.
Flashing
2. Use the [||] keys to move the flashing
(editing) point and use the jog dial or numeric keys
to enter a desired value.
3. After entering the desired value, press the
[ENTER/YES] key.
"Wait!" is shown for a while, and the new subnet mask
is set.
4. To exit the Setup mode, press the [EXIT/NO] key
or [STOP] key.
11-9