audio file in the INSERT mode - Fostex

More documents

Recommendations

Info

About REMAIN display You can check the remaining (recordable) time/space by selecting the appropriate display using the [DISP TIME] key. The unit can show the remaining time and space that can be used for "Normal mode" files, regardless of whether the disk is formatted in the "Normal" or "Tape" mode. • If a disk is formatted in the Normal mode 1. While a disk is stopped and the display shows "No Audio FIles!", press the [DISP TIME] key three times. The display shows the "FreeArea" screen, in which the recordable space (in MB) and time (in hours/minutes/ seconds) for files with the current [TRACK MODE] and [SAMPLING FREQ] switch settings are shown. The screen example on the right below shows the recordable time and space when the disk is formatted with the [TR MODE] and [SAMPLING FREQ] switch settings to "MONO" and "44.1 kHz/24 bit" respectively. ABS H M S F PGM 1 BIT 24 H M S 1 BIT 24 2. Press the [TR MODE] and [SAMPLING FREQ] switches as desired. By changing the [TRACK MODE] and [SAMPLING FREQ] switch settings, you can check the recordable space and time according to the current switch settings. The screen examples below shows the values in two cases when the [TR MODE] switch is set to "STEREO" and "MULTI (4TR)" while the [SAMPLING FREQ] switch is fixed to "44.1 kHz/24 bit". REMAIN MB TR MODE -> "STEREO" TR MODE -> "MULTI (4TR)" REMAIN REMAIN H M S H M S MB BIT 1 BIT 24 MB • If a disk is formatted in the Tape mode 1. While the "Tape mode" audio file is selected, press the [DISP TIME] key three times. The display shows the “FreeArea” screen, as with a disk formatted in the Normal mode. In this screen, the recordable space (in MB) and time (in hours/minutes/seconds) for “Normal mode” files, with the same track mode and sampling frequency/bit length settings as when the disk is formatted, are shown. In other words, the recordable space shown here is the value calculated by subtracting 4.0 GB from all recordable space of the disk. The screen example on the right below shows the values when the disk is formatted by setting the [TR MODE] and [SAMPLING FREQ] switches to “MONO” and “48kHz/24bit” respectively. The recording time in mono is 47 minutes 30 seconds, while the available space is 0.4 GB. Note that, with a disk formatted in the Tape mode, if you change the settings of the [TR MODE] and [SAMPLING FREQ] switches, the values on the display may not be changed. REMAIN H M S F ABS PGM 1 BIT 24 H M S 1 BIT 24 MB The recordable space of each “Tape mode” file is fixed to approximately 2.0 GB, which is not included in the Free Area, as shown above. You can see the maximum recordable time of the “Tape mode” audio file by following the operation below. * While a disk is stopped, press the [F FWD] key while holding down the [STOP] key. The current position moves to the end of the “tape”, and the maximum recordable time of a “Tape mode” file, with the track mode and sampling frequency/bit length selected by the [TR MODE] and [SAMPLING FREQ] switches when formatted, is shown on the display. The example on the right below shows that the maximum recordable time in mono is approximately 3 hours 53 minutes. You can calculate the remaining time of a “tape mode” file by subtracting the elapsed time from the maximum recordable time. H M S F ABS H M S F ABS PGM 1 BIT 24 PGM 1 BIT 24 1-8
Chapter-2 Names and Functions This chapter describes names and functions of controls on the front panel, as well as those of connectors on the rear panel. 2-1
Page 1 and 2: KEYBOARD MOUSE SOURCE PLAY LOCATE A
Page 3 and 4: Table of Contents Chapter-1 Before
Page 5 and 6: Chapter-9 Audio file management Cre
Page 7 and 8: Chapter-1 Before using the DV40 Bef
Page 9 and 10: Setting the internal clock The inte
Page 11 and 12: Formatting a DVD-RAM disk To make a
Page 13: About audio files on a formatted di
Page 17 and 18: Front panel part 1 3 4 5 6 7 DVD MA
Page 19 and 20: c. [PLAY] key Normally, pressing th
Page 21 and 22: DISP TIME 15. [DISP TIME] key Cycle
Page 23 and 24: CUE POINT IN DST OUT PREVIEW TR3 TR
Page 25 and 26: NEW FILE INPUT MON 40. [AUDIO RDY -
Page 27 and 28: 50. [TC GEN MODE] switch Selects th
Page 29 and 30: 4. ETHERNET port ETHERNET 10/100 LI
Page 31 and 32: Chapter 3 Reformatting/optimizing a
Page 33 and 34: Tips: How to edit a volume name Whi
Page 35 and 36: Optimizing a disk By optimizing a u
Page 37 and 38: Chapter 4 Audio recording/playback
Page 39 and 40: Recording an analog source in the N
Page 41 and 42: Recording 1. Press the [RECORD] key
Page 43 and 44: You can create an audio file before
Page 45 and 46: Selecting a desired file on a disk
Page 47 and 48: Creating a "Normal mode" audio file
Page 49 and 50: KEYBOARD MOUSE SOURCE PLAY LOCATE A
Page 51 and 52: MUTE recording You can make mute re
Page 53 and 54: Cueing by the jog function You can
Page 55 and 56: Chapter 5 Timecode recording This c
Page 57 and 58: ABS H M S F PGM Recording timecode
Page 59 and 60: TC Setup mode details The TC Setup
Page 61 and 62: • Selecting output timecode When
Page 63 and 64: • Catch offset you can capture th
Page 65 and 66:
Chapter 6 Storing time data This ch
Page 67 and 68:
Storing a time to an edit point mem
Page 69 and 70:
Storing a time to a locate point me
Page 71 and 72:
• Storing a time to a locate poin
Page 73 and 74:
Clearing a CUE or MEMORY point memo
Page 75 and 76:
Chapter 7 Locate functions This cha
Page 77 and 78:
• Location to the last playback s
Page 79 and 80:
• Location to a MEMORY point By s
Page 81 and 82:
Chapter 8 Preview function This cha
Page 83 and 84:
• Preview at a locate point You c
Page 85 and 86:
Chapter 9 Audio file management Thi
Page 87 and 88:
• Creating a new file on a disk j
Page 89 and 90:
Editing an audio file name You can
Page 91 and 92:
Restoring a deleted audio file You
Page 93 and 94:
Converting the audio file format Yo
Page 95 and 96:
Combining audio files You can combi
Page 97 and 98:
Chapter 10 Editing track data This
Page 99 and 100:
Tips: SOURCE-PLAY You can monitor t
Page 101 and 102:
Flashing Tips: You can monitor the
Page 103 and 104:
5. Press the [ENTER/YES] key. The u
Page 105 and 106:
4. Press the appropriate edit point
Page 107 and 108:
Chapter 11 Setup mode In the Setup
Page 109 and 110:
You can control the display contras
Page 111 and 112:
Panel lock on/off You can select wh
Page 113 and 114:
4. After entering a desired name, p
Page 115 and 116:
• Showing the router IP address 1
Page 117 and 118:
Showing the main software version Y
Page 119 and 120:
Chapter 12 Utility mode This chapte
Page 121 and 122:
Selecting Rec Protect On or Off You
Page 123 and 124:
Chapter 13 Importing an audio file
Page 125 and 126:
4. Select the desired directory ("b
Page 127 and 128:
9. Click on in the Spot Dialog wind
Page 129 and 130:
Chapter 14 Specifications 14-1
Page 131 and 132:
Pin 5:
Page 133 and 134:
Declaration of EC Directive This eq
show all

audio file in the INSERT mode - Fostex

Create successful ePaper yourself

Delete template?

Save as template?