audio file in the INSERT mode - Fostex

More documents

Recommendations

Info

Recording a digital source in the NEW FILE mode The following describes how to record a digital source in the NEW FILE mode. In the same way as recording an analog source, you can record a digital source in the NEW FILE mode to a disk formatted in the Normal mode. We assume that we are going to record a digital audio source in stereo. Connection to external devices Preparation 1. Connect the external digital source outputs to the [TR2-1] of the [DIGITAL INPUT] section of the unit. Channels L and R of the source are assigned to tracks 1 and 2 of the unit respectively. The digital input signal format (AES/EBU or S/P DIF) is automatically recognized. When receiving a stereo digital signal with 176.4 kHz or 192 kHz Fs, connect channels L and R of the source to [TR2-1] and [TR4-3] of the [DIGITAL INPUT] section respectively. 2. Connect a pair of monitor speakers with built-in amplifiers or an amplifier/speaker system to the [TR 1] and [TR 2] connectors of the [ANALOG OUTPUT] section of the unit. 3. If you want to lock the unit to a word or video signal, feed an appropriate external clock signal to the [WORD IN] or [VIDEO IN]. External Digital Device Digital Signal (AES/EBU or S/P DIF) Word Clock or Video sync TIME CODE MONITOR ETHERNET ANALOG INPUT BALANCED ANALOG OUTPUT DIGITAL INPUT VIDEO TR3 TR1 BAL [+4dBu] TR3 BAL [+4dBu] TR1 INPUT TR4-3 TR2 TR2-1 TR1 INPUT THRU 75Ω ON OFF VGA +4dBu -10dBV TR4 +4dBu -10dBV TR2 UNBAL [-10dBV] BAL [+4dBu] TR4 UNBAL [-10dBV] BAL [+4dBu] TR2 THRU VIDEO 10/100 LINK DIGITAL OUTPUT TR4-3 TR2 TR2-1 TR1 WORD INPUT 75Ω ON OFF THRU OUTPUT OUTPUT TX/RX 1:GND 2:HOT 3:COLD TR1 TR2 192kHz 176.4kHz AC IN GPI INPUT OUTPUT +4dBu +4dBu UNBAL UNBAL 15P-REMOTE 9P-REMOTE -10dBV -10dBV [-10dBV] 1: GND 2: HOT 3: COLD 1: GND 2: HOT 3: COLD [-10dBV] 1: GND 2: HOT 3: COLD 4-12
KEYBOARD MOUSE SOURCE PLAY LOCATE ABS 0 LOCATE REC END ABS H M S F PGM ON OFF BY- PASS BY- PASS ON OFF Preparation for recording 8 10 5 DVD MASTER RECORDER OPEN/CLOSE DISP TIME SETUP FILE SEL VARI PITCH JOG SHUTTLE SKIP/CURSOR 1 2 BIT FS kHz 24 48 96 DISP LEVEL UTILITY DIRECTORY SHIFT DRIVE TAPE MODE CHASE LIST PLAY - + ∞ 60 50 42 34 28 2018 12 8 6 5 4 3 2 1 0 OL -0.1% CLOCK -INT- FORMAT BWF MARGIN RESET EXIT/NO ENTER/YES POWER DVD HD space ABC DEF RECORD STOP PLAY TC SETUP REWIND EDIT F FWD 1 2 3 GHI JKL MNO INPUT MON MUTE SLATE TONE IN SOURCE OUT IN DST OUT CUE POINT MEMORY 4 5 6 PQRS TUV WXYZ symbol 7 8 9 0 MUTE REC TONE REC PREVIEW AUDIO RDY TR1 TR2 TR3 TR4 NEW FILE INSERT TC RDY AUDIO EDIT UNDO LOCATE STORE HOLD MIN TR1,3+2,4 TR3+4 TR1+2 MAX PHONES TR4 TR3 TR2 TR1 MONO 176.4 192 30 30DF 24H RUN 96 24BIT 29.97 REC RUN REMOTE BWF ANALOG MONO +0.1% 88.2 29.97DF FREE RUN STEREO NORM (kHz) LOCAL SDII DIGITAL 48 25 EXT RUN MULTI(4TR) -0.1% 44.1 16BIT 24 PULL 48 44.1 RSVD 23.97 CONTROL AUDIO FILE INPUT TR MODE UP/DOWN SAMPLING FREQ FRAME RATE TC GEN MODE INT WORD VIDEO DIGITAL MIN CLOCK TR1 MAX MIN TR2 INPUT LEVEL MAX TR3 TR4 1. Set the [CONTROL] switch to "LOCAL". 2. Set the [AUDIO FILE] switch to "BWF" or "SDII" appropriately. When starting recording, an audio file with the selected file format is automatically created. 3. Set the [INPUT] switch to "DIGITAL". "DIGITAL" is shown on the display. It lights steadily or flashes depending on whether the appropriate digital signal is fed or not. 4. Set the [TR MODE] switch to "STEREO". 9 1 2 3 4 6 7 5. Select the digital input tracks using the "D. IN Tr?" menu in the Setup mode, if necessary. The "D. IN Tr?" menu is initially set to "Auto", in which the track numbers correspond to the input numbers. See "Chapter 11: Setup mode" for details about the "D. IN Tr?" menu. 6. Set the [SAMPLING FREQ] switch to the desired Fs/Bit position. 7. Set the [CLOCK] switch to "DIGITAL". "DIGITAL" and "-EXT-" light up in the "CLOCK" section on the display, showing that the system clock is derived from the digital input signal. If you wish to make the unit slaved to a video or word clock, select the [CLOCK] switch to "VIDEO" or "WORD" appropriately. 8. Press the [AUDIO RDY - NEW FILE] key to select the NEW FILE mode (the NEW FILE indicator is lit). If you wish to record timecode simultaneously, press the [TC RDY] key to turn on the indicator. See "Chapter 5: Timecode recording" for details about timecode recording. 9. Connect a pair of headphones to the [PHONES] jack, and set the monitor track select switch to "TR1 + TR2" position. 10. Press the [INPUT MON] key to turn on the indicator. You do not need to adjust the input level for digital recording. You can check digital input levels from the level meters by activating the input monitor mode. Recording 1. Press the [RECORD] key. "New File!" appears for a short time on the display and the unit starts recording on the newly created file. 2. After recording, press the [STOP] key to stop the unit. If you are not satisfied with the result, undo the recording. 4-13
Page 1 and 2: KEYBOARD MOUSE SOURCE PLAY LOCATE A
Page 3 and 4: Table of Contents Chapter-1 Before
Page 5 and 6: Chapter-9 Audio file management Cre
Page 7 and 8: Chapter-1 Before using the DV40 Bef
Page 9 and 10: Setting the internal clock The inte
Page 11 and 12: Formatting a DVD-RAM disk To make a
Page 13 and 14: About audio files on a formatted di
Page 15 and 16: Chapter-2 Names and Functions This
Page 17 and 18: Front panel part 1 3 4 5 6 7 DVD MA
Page 19 and 20: c. [PLAY] key Normally, pressing th
Page 21 and 22: DISP TIME 15. [DISP TIME] key Cycle
Page 23 and 24: CUE POINT IN DST OUT PREVIEW TR3 TR
Page 25 and 26: NEW FILE INPUT MON 40. [AUDIO RDY -
Page 27 and 28: 50. [TC GEN MODE] switch Selects th
Page 29 and 30: 4. ETHERNET port ETHERNET 10/100 LI
Page 31 and 32: Chapter 3 Reformatting/optimizing a
Page 33 and 34: Tips: How to edit a volume name Whi
Page 35 and 36: Optimizing a disk By optimizing a u
Page 37 and 38: Chapter 4 Audio recording/playback
Page 39 and 40: Recording an analog source in the N
Page 41 and 42: Recording 1. Press the [RECORD] key
Page 43 and 44: You can create an audio file before
Page 45 and 46: Selecting a desired file on a disk
Page 47: Creating a "Normal mode" audio file
Page 51 and 52: MUTE recording You can make mute re
Page 53 and 54: Cueing by the jog function You can
Page 55 and 56: Chapter 5 Timecode recording This c
Page 57 and 58: ABS H M S F PGM Recording timecode
Page 59 and 60: TC Setup mode details The TC Setup
Page 61 and 62: • Selecting output timecode When
Page 63 and 64: • Catch offset you can capture th
Page 65 and 66: Chapter 6 Storing time data This ch
Page 67 and 68: Storing a time to an edit point mem
Page 69 and 70: Storing a time to a locate point me
Page 71 and 72: • Storing a time to a locate poin
Page 73 and 74: Clearing a CUE or MEMORY point memo
Page 75 and 76: Chapter 7 Locate functions This cha
Page 77 and 78: • Location to the last playback s
Page 79 and 80: • Location to a MEMORY point By s
Page 81 and 82: Chapter 8 Preview function This cha
Page 83 and 84: • Preview at a locate point You c
Page 85 and 86: Chapter 9 Audio file management Thi
Page 87 and 88: • Creating a new file on a disk j
Page 89 and 90: Editing an audio file name You can
Page 91 and 92: Restoring a deleted audio file You
Page 93 and 94: Converting the audio file format Yo
Page 95 and 96: Combining audio files You can combi
Page 97 and 98: Chapter 10 Editing track data This
Page 99 and 100:
Tips: SOURCE-PLAY You can monitor t
Page 101 and 102:
Flashing Tips: You can monitor the
Page 103 and 104:
5. Press the [ENTER/YES] key. The u
Page 105 and 106:
4. Press the appropriate edit point
Page 107 and 108:
Chapter 11 Setup mode In the Setup
Page 109 and 110:
You can control the display contras
Page 111 and 112:
Panel lock on/off You can select wh
Page 113 and 114:
4. After entering a desired name, p
Page 115 and 116:
• Showing the router IP address 1
Page 117 and 118:
Showing the main software version Y
Page 119 and 120:
Chapter 12 Utility mode This chapte
Page 121 and 122:
Selecting Rec Protect On or Off You
Page 123 and 124:
Chapter 13 Importing an audio file
Page 125 and 126:
4. Select the desired directory ("b
Page 127 and 128:
9. Click on in the Spot Dialog wind
Page 129 and 130:
Chapter 14 Specifications 14-1
Page 131 and 132:
Pin 5:
Page 133 and 134:
Declaration of EC Directive This eq
show all

audio file in the INSERT mode - Fostex

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?