audio file in the INSERT mode - Fostex

• Storing a time to a locate point memory (CUE or MEMORY point memory) "on the fly"
During playback, you can store a desired time to a locate point memory (CUE or MEMORY
point memory) "on the fly".
1. Press the [PLAY] key to start playback.
2. Press the [STORE] key at the point you want to store.
The time data at the point when pressing the key is held and the display shows "Select Memories?" with a
flashing point number. The first time you press the [STORE] key after turning on the power, "CUE" is lit and
"01" flashes, showing that the time data is going to be stored to CUE "01".
If one or more CUE points already hold data, one greater than the highest CUE point number which holds
data is shown.
"CUE" is lit
H M S F SF
CUE ABS
NEXT
1
BIT
FS
2
kHz
∞ 60 50 42 34 28 2018 12 8 6 5 4 3 2 1 0 OL -0.1%
FORMAT
BWF
48
24
CLOCK
-INT-
flashing
Tips: Bank selection
When storing time data to a locate point memory "on the fly" by pressing the [STORE] key, the destination
bank (the CUE or MEMORY bank) is initially selected to the one previously used for storing time
data. The first time you press the [STORE] key after turning on the power, the CUE bank is selected
(shown by "CUE" lit on the display).
If you store time data to a locate point memory in the currently selected bank, go to step 3-1.
If you store time data to a locate point memory in the bank which is not currently selected, go to step
3-2. (Pressing the appropriate locate point key for the first time switches the bank.)
"MEMORY" is lit
ABS
MEMORY
H M S F SF
NEXT
1
BIT 24
2
FS
kHz
48
∞ 60 50 42 34 28 2018 12 8 6 5 4 3 2 1 0 OL -0.1% CLOCK
FORMAT
-INT-
BWF
flashing
3-1. To store the time data to a locate point memory in the current bank, press the appropriate locate
point key ([MEMORY] or [CUE POINT] key).
The time data is stored to the flashing locate point memory in the current bank, and the display returns to
the previous screen.
Tips:
You can select the locate point memory number using the jog dial while the memory number is flashing.
3-2. To store the time data to a locate point memory in the bank which is not currently selected, press the
appropriate locate point key ([MEMORY] or [CUE POINT] key) twice.
Pressing the key for the first time switches the current bank. Pressing the key again stores the time data to
the flashing locate point memory in the newly selected bank, and the display returns to the previous
screen.
Tips:
If you store another time data to a locate point memory in the newly selected bank, you do not need
to press the appropriate key twice.
6-6