audio file in the INSERT mode - Fostex

4. ETHERNET port
ETHERNET
10/100
LINK
TX/RX
5. Digital input/output section
A
1:GND
2:HOT
3:COLD
DIGITAL INPUT
TR4-3
TR2
DIGITAL OUTPUT
TR4-3
TR2
TR2-1
TR1
6. Video clock section
TR1
TR2
B
* Connects to an Ethernet network.
* Connector: IEEE802.3, conformed
to 10BASE-T/100BASE-T
* LED indicators
• 10/100: When the connection to
a network is established by
100BASE-TX, this indicator is lit.
(It is not lit when the connection
is established by 10BASE-T.)
• LINK: When the unit recognizes the
network, this indicator is lit.
• TX/RX: When data is transmitted
or/and received, this indicator is
lit.
192kHz
176.4kHz
TR2-1
TR1
A. DIGITAL INPUT connectors
* Each connector accepts a digital signal conformed
to the IEC 60958 (AES/EBU) or IEC 60958 (S/P
DIF) format. The unit can automatically detect the
format.
* Connectors: XLR-3-31 type
B. DIGITAL OUTPUT connectors
* Each connector outputs a digital signal conformed
to the IEC 60958 (AES/EBU) or IEC 60958 (S/P
DIF) format. The format is selected in the Setup
mode.
* Connectors: XLR-3-32 type
VIDEO
2
1
3
3
1
2
7. AC IN connector
Connect the supplied power cord.
8. Word clock section
INPUT
75Ω
ON OFF
WORD
9. GPI input/output connectors
These connectors are active only when the "GPI ON/
OFF" menu in the Setup mode is set to "On". It is set
to "Off" in the initial setting, therefore, you have to
change it to "On" before using the GPI connectors.
THRU
A B C D
OUTPUT
A. WORD INPUT connector
* Accepts a word clock signal.
* Connector: BNC type
B. 75Ω (ON/OFF) switch
* To terminates the word clock, set this switch to
ON.
C. WORD THRU connector
* Echoes an incoming word clock signal.
* Connector: BNC type
D. WORD OUTPUT connector
* Outputs a word clock signal from the unit.
* Connector: BNC type
A
INPUT
GPI
B
OUTPUT
A. GPI INPUT connector
* Connector: DIN-5 pin
* The following table shows the pin assignment.
A TTL-level, low active input signal activates the
operation.
5
4
3
2
1
INPUT
75Ω
ON OFF
THRU
Pin-1
GND
Pin-2 STOP The low plus signal activates the operation
equivalent to the STOP key operation.
A B C
A. VIDEO INPUT connector
* Accepts a video clock signal.
* Connector: BNC type
B. 75É∂ (ON/OFF) switch
* To terminates the video clock, set this switch to
ON.
C. VIDEO THRU connector
* Echoes an incoming video signal.
* Connector: BNC type
Pin-3 PLAY The low pulse signal activates the operation
equivalent to the PLAY key operation.
Pin-4 >> The low pulse signal activates the operation
equivalent to the SKIP >> key operation.
Pin-5