Omega-Voice VMI Technical Manual (5th Edition) (PN 500175)

Chapter 1
IX-4EVMC
5. At the sh380 [Iwatsu] DATA:> prompt, type the following in lowercase lettering.
boot
Note:
After typing ‘boot’, do not close the terminal window. If the terminal window is closed, the
Enterprise-CS must be reset.
6. At the Select your System Volume Prompt, select 2.
If 2 is not selected with 5 seconds, the reboot process begins. If this occurs, wait until the IX-
4EVMC reboots. Then, follow the instructions on page 18.
A series of options now displays in the Backup Volume terminal window.
Exit and mount data volume: Factory use only; do not modify.
Run Support Utility: Factory use only; do not modify.
Default programs volume of this unit: This option overwrites all of the program files on the
Programs volume with the program files on the Backup volume. This option only affects
application files. All greetings, messages, and programming of menus, mailboxes, and
integration are left intact.
Default data volume of this unit: This option leaves the application files intact and defaults the
customer data (greetings, messages, and programming of menus, mailboxes, and integration).
Exit to command line with Ethernet: Factory use only; do not modify.
Exit to command line: Factory use only; do not modify.
Reboot: Reboots the IX-4EVMC card.
7. Continue to either the Defaulting Program Volumes (page 20) or Defaulting Data Volumes (page
21) instructions below.
19