0 Contents - Hilti Svenska AB

Fastener selection and system recommendation
Fastening to concrete
Depth of penetration, hET [mm]
32
30
28
26
24
22
5
ZF37
ZF47
ZF62
10 15 20 25 30
Fastened thickness, tI [mm]
System recommendation
Green concrete
Normal concrete
OId concrete
For unusual applications, X-SW with other nail available on order
Example 1: tI = 40 and normal concrete ==> X-ZF 72
Example 2: tI < 5 and steel base material ==> X-EDNI 22
Fastener Tools
Designation Item no. Ls [mm] Designation
X-SW 30, X-SW 60
➀ X-SW 30 ZF 37 40643 37 DX 460, DX 36, DX-E 72
➀ X-SW 30 ZF 47 40 644 47 DX 460, DX 36, DX-E 72
➀ X-SW 30 ZF 62 40 645 62 DX 460, DX 36, DX-E 72
➁ X-SW 60 ZF 37 40 617 37 DX 460, DX 36, DX-E 72
➁ X-SW 60 ZF 47 40 618 47 DX 460, DX 36, DX-E 72
➁ X-SW 60 ZF 62 40 619 62 DX 460, DX 36, DX-E 72
➂ X-SW 30 371370 DX 460-MX with collated
➂ X-SW 60 371371 X-ZF nails (3.5 mm shank dia.)
Cartridge selection and tool energy setting
• X-SW 30 for stronger, less damageable
material.
• X-SW 60 for more easily damaged material
(i.e. aluminum foil, nets, paper, etc.)
• Select ZF 37, ZF 47 and ZF 62 according
to base material conditions and fastened
thickness
Cartridge recommendation: Concrete 6.8/11M yellow or red
Masonry: 6.8/11M green
Tool energy adjustment by setting tests on site.
Fastening quality assurance
Installation
1. Load X-SW fastener on
cyclic tool
2. Press the X-SW against
the surface
3. Pull the trigger to fasten
11 / 2007 4.171