0 Contents - Hilti Svenska AB

X-FCP
Load data
Design data
Recommended loads:
Nrec = 1.8 [kN]
Test data
For test data please see corresponding pages for X-CRM threaded studs.
Application requirements
Thickness of base material
X-CRM8
tII
Minimum steel thickness tII ≥ 6 mm
Spacing and edge distances
X-CR M8
Edge distances: c ≥ 15 mm
Spacing: s ≥ 15 mm
c c s s
Conditions:
• Limited by the strength of the X-CRM8 threaded
stud.
• Recommended loads are valid for fastenings of steel
and aluminum with 20 mm pre-drilling.
• X-FCP-F and X-FCP-R are not intended for shear
loading.
Thickness of fastened material
Thickness of checker plates: tI ≅ 5.0–13.0 mm
Corrosion information
The intended use of standard carbon steel fasteners only comprises fastenings which are not
directly exposed to external weather conditions or moist atmospheres. For out-door applications
stainless steel fasteners have to be used, see fastener selection. Further detailed information
on corrosion see corresponding chapter in section Direct Fastening Technology.
4.80 11 / 2007