0 Contents - Hilti Svenska AB

X-EDNK22 THQ12,
X-EDN19 THQ12
Spacing and edge distances (mm)
Steel base material
Rolled I or wide flange shape Angles
10
* For tII = 3–4 mm, restrictions on application. See approval or contact Hilti.
** Maximum recommended bx ≤ 8 x tII however, jobsite verification advisable
Trapezoidal profiles
Center fastenings in
ribs
20
Corrosion information
The intended use only comprises fastenings which are not directly exposed to external
weather conditions or moist atmospheres. For further detailed information on corrosion see
corresponding chapter in section Direct Fastening Technology.
Recommended setting range
Clearance to end of
sheet
S235 S355
X-EDNK22 3– 6 mm 3–6 mm
X-EDN19 5–10 mm 5–8 mm
For tII = 3–4 mm, restrictions on application.
See approval or inquire at Hilti.
4.38 11 / 2007
20
bx**
10
45
Double fastenings
Note:
Reduced recommended load per fastening.
Reduction depends on actual spacing and conditions.
Inquire at Hilti.