Pano System for Cloud Administrator's Guide - Pano Logic

of a certain thickness; given the variety in monitor stands on the market it’s possible that you
might need to purchase screws to accommodate the thickness of the monitor stand.
Optionally, one of the mounting brackets can be used as a wall mount if you prefer to mount the
Pano Zero Client on the wall. Pano Logic does not recommend using any adhesives (for example,
Loctite) on the screws to secure the Pano System Endpoint because you can damage the Pano
Zero Client; doing so will void your Pano Zero Client hardware warranty. Instead, use a lock
washer or self-locking nut, such as a Nylock.
Pano Zero Client Hardware Specifications
This section gives the mechanical and electrical specifications for the three Pano Zero Client
models. The models are easy to distinguish at a glance:
• Pano G2M is a small, rectangular box with a DVI video connector.
• Pano G2 is a slightly larger square box, also with a DVI video connector.
• Pano G1 is very similar to Pano G2, but it has a VGA connector.
Item Pano G2M Pano G2 Pano G1
I/O: Four USB 2.0 ports Three USB 2.0 ports
Primary Video
Display:
One DVI-I port capable of driving one DVI-D display, or one VGA
display using the DVI-to-VGA adapter supplied
Networking: 10/100 Base-T Fast Ethernet twisted pair (RJ-45)
Audio: Internal speaker for audio output. Single 1/8 inch mini-jack supports
audio in and out. Works with iPhone-compatible 4-ring connector /
3.5mm TRRS (tip-ring-ring-sleeve) plug. Using a 4-ring splitter such as
KM-IPHONE-2TRS, you can provide a separate jack for speakers and
microphone. Audio input is transmitted as 16-bit samples.
Tip: Left audio out Sleeve: Mic
Ring 1: Right audio out Ring 2: Gnd
Physical
Characteristics:
Height: 0.75” /19 mm
Width: 4.50” / 113 mm
Depth: 3.50” / 89 mm
33 � Pano System for Cloud Administrator’s Guide
VGA-type video output
Height: 2.00” /51.0mm
Width: 3.50” / 88.8mm
Depth: 3.50” / 88.8mm
Output: Internal speaker;
1/8-inch mini jack
Input: 1/8-inch mini microphone
jack
Power: Worldwide auto-sensing 100-240 VAC, 50/60 Hz. Average power use with keyboard, mouse and display
connected: 6.5 watts. Pano G2M and Pano G2 each have 4 USB ports; Pano G1 has 3. The combined
power draw from all ports cannot exceed 1400 mA; no individual port should draw more than 500mA.
Power over Ethernet (PoE) cannot be used directly to power the Pano System Endpoint; however, you can
use a PoE adapter such as D-Link DWL-P50. This device takes a PoE input and outputs separate Ethernet
and power channels which can be connected directly to the Pano System Endpoint. Using such an adapter
eliminates the need for the wall socket power adaptor that comes standard with the Pano System
Endpoint. Also, you can connect PoE to the network connector on the Pano System Endpoint and still use
the wall socket power adaptor that comes standard with the Pano System Endpoint.
Temperature
Range:
50° to 104°F, (10° to 40°C)
Humidity: 20% to 80% non-condensing
Weight: 1.1 lbs / 500 grams
Regulatory
Compliance
RF Interference: FCC Class A, CE
Warranty Three-year limited warranty