Programming Guide DS2000 Series Digital Oscilloscope

RIGOL
2 Command System
:AUToscale
Syntax
:AUToscale
Description
Enable the auto setting function.
Explanation
This command is not available when the current state of the Pass/Fail function is
“Enable Test”. For details, refer to the :MASK:ENABle command.
The oscilloscope will adjust the vertical scale, horizontal time base and trigger mode
for optimum display of the waveform. Note that to use the auto setting, the
frequency of the signal under test should be no lower than 50 Hz, the duty cycle be
greater than 1% and the amplitude be at least 20 mVpp.
2-2 DS2000 Programming Guide
2-2