workshop manual rear axles rf17n/h r17n/h - Marmon-Herrington

2. ábra: A KAPCSOLÓAGY LEHÚZATÁSA
REPLACING THE SEALING Fig. 2.: RINGS PULLING IN OFF THE COMPANION FLANGE
THE COVER
TÖMÍT�GY�R�K Back out the hex. CSERÉJE bolts (6) and A FEDÉLBEN
remove the cover (5) REPLACING Drive in the new THE sealing SEALING rings (see RINGS Fig. 3. and IN 4.). THE
and the shims (67).
COVER
Hajtsuk ki a hatlapfej� csavarokat (6) és vegyük le a Apply specified grease to between the sealing lip and
fedelet Remove (5), és a the hézagoló used sealing lemezeket rings (67). (4) from the cover, Back the out dust the protection hex. bolts edge (6) and of the remove outer the sealing cover ring, (5)
No. RA-0039 and RA-1241 of the tools
and while the shims thin coat (67). of grease (AMBLYGON TA 15/2) to the
inner one.
A fedélb�l az elhasználódott tömít�gy�r�ket (4) üssük Remove the used sealing rings (4) from the cover, No.
ki, az RA-0039 és az RA-1241 jel� szerszámokkal.. RA-0039 and RA-1241 of the tools
Üssük be az új tömít�gy�r�ket (3. és 4. ábra).
75x95x10
842.02-13 842.02-14
3. ábra: Fig. A 3.: BELS� DRIVING TÖMÍT�GY�R� IN THE INNER SEALING BEÜTÉSE RING 4. ábra: Fig. 4.: A DRIVING KÜLS� IN TÖMÍT�GY�R� THE OUTER SEALING BEÜTÉSE RING
Fig. 3.: DRIVING IN THE INNER SEALING RING Fig. 4.: DRIVING IN THE OUTER SEALING RING
INSTALLING THE COVER
When installing the cover (5) adjust the axial play of
the input shaft as described in the Section 293., then
as described in the “GENERAL INSTRUCTIONS” apply
oil-proof (LOCTITE 515) surface sealant to the
protruding corner surface of the outer taper roller
bearing on the input shaft.
50
783.24-61
Drive in the new sealing rinsg (see Fig. 3. and 4.).
75x95x10
75
Aligning the bores install the necessary shim pack
(67) and the cover subassembled with sealing rings,
Attach to the differential carrier III. by means of lock
washer (7) and hex. bolts (6). Tighten the bolts to
59 - 78 Nm torque.