AS9N010B.STB AS-93plus Service Manual.fm - LIQUID-scan GmbH ...

Positioning the autosampler
The autosampler requires the same environmental conditions as the spectrometer.
Please refer to the guide provided with your spectrometer for details.
When used alone, the autosampler is connected directly to the nebulizer’s sample tube.
Since the length of the sample tube has an influence on the aspiration rate of the
nebulizer, you should position the autosampler as close to the spectrometer as possible.
The best position is on a suitable table or trolley (cart) in front of the spectrometer’s
atomizer compartment. With some spectrometers it is possible to place the autosampler
on a sample tray directly in front of the atomizer compartment.
If you are using a diluter system, such as the AutoPrep-50, you can place this next to the
autosampler to keep the sample tubes as short as possible.
Autosampler
Spectrometer
Nebulizer
Sample tube
Figure 3 Suggested Arrangement for the System (1)
14 of 68 AS9N010B.STB