You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
APPENDIX > INSTALLATION INFORMATIONConnecting Your 276C Plus to a ComputerYour 276C Plus can be connected to your computer using thesupplied USB cable to connect to a USB data port or the optional PCInterface Cable to connect to a DB-9 serial communications port.NOTE: Fully install the supplied MapSource program, Trip &Waypoint Manager, on your computer before connecting the USBcable to the computer.To connect your GPS to your computer:1. Raise the rubber weather cap to expose the connectors.Connect the small end of your cable to the lower connectoron the back of the 276C Plus.2. When using the supplied USB Data Cable, connect the largerend of the cable to an available USB data port (see below).USB Data PortWhen using a PC Interface Cable, connect the larger end ofthe cable to a serial communications port on your computer(see below).Serial Communications PortUSBconnectorunderweather capInformation about USB DriversThe USB drivers should have been automatically installed whenyou installed the MapSource program that came with your 276CPlus. When you initially connect the 276C Plus to a USB port, yourcomputer may prompt you to locate the destination of the driversfor the device. You only need to install the drivers once. After thedrivers are installed, your computer will always detect your 276CPlus when it is connected. USB drivers may be updated periodically.You can find these updates at www.garmin.com.110 276C Plus Owner’s <strong>Manual</strong>190-00501-00_0A.indd 1101/13/2005 10:44:11 AM
Change language