Owner's Manual - West Marine

SEA MODES PAGES AND FEATURES > MAP PAGEChanging the Map DetailYou can adjust the detail of the Map page while you are inPowerboat mode or Sailboat mode. To quickly change the mapdetail, press ENTER.To change the map detail shown on the Map page:1. From the Map page, press MENU to open the options menu.2. Use the Rocker key to highlight Change Map Detail andpress ENTER.3. Use the Rocker key to adjust the slider; move the slider rightto increase the detail shown on the Map page, or move it leftto decrease the detail.4. Press ENTER or QUIT to close the Map Detail window.Measuring DistanceYou can measure the distance and bearing between two map items.To measure the bearing/distance between two points:1. From the Map page, press MENU to open the options menu.2. Highlight Measure Distance and press ENTER. An onscreenarrow appears on the map display at your presentposition with ENT REF below it.3. Move the arrow to the desired reference point (the startingpoint that you want to measure from) and press ENTER. Apush-pin icon marks the starting point on the map display.Push pinindicatingthe beginningpoint of themeasurementMeasure DistanceEnd point ofmeasurement,labeled ENTREF4. Move the arrow to the point you want to measure to. Thearrow’s coordinates and its bearing and distance from thereference point are displayed in the data window at the top ofthe display.5. Press QUIT to finish.276C Plus Owner’s Manual 45190-00501-00_0A.indd 451/13/2005 10:43:40 AM