Owner's Manual - West Marine

More documents

Recommendations

Info

ADDITIONAL FEATURES > SETTING ALARMSADDITIONAL FEATURESThe Main Menu features some additional pages that will be useful toyou as you plan trips and use your 276C Plus. Some of these pageshave already been discussed in-depth in previous sections. Thissection only contains the additional pages and features found in theMain Menu that have not been discussed yet.Press the MENU key twice to open the Main Menu.Setting AlarmsThe Alarms tab of the Main Menu allows you to define alarmsettings. When an alarm goes off, the alarm message appears on thedisplay and the unit emits five (5) beeps. When you set an alarm tobe persistent, the alarm message appears on the display and the unitbeeps until you press ENTER to acknowledge the alarm.To set an alarm:1. Press MENU twice to open the Main Menu.2. Use the Rocker key to open the Alarms tab.3. Highlight the alarm you want to activate and press ENTER.4. Change the mode to On (or the desired mode, whereavailable) and press ENTER. If necessary, highlight thenext field to the right and press ENTER, enter the desiredsettings, and press ENTER to finish.Navigation Alarms TabTo set a persistent alarm:1. Press MENU twice to open the Main Menu.2. Use the Rocker key to open the Alarms tab.3. Highlight the box next to the alarm you would like to makepersistent (for example, Restricted Areas).4. Press ENTER to place a check mark in the Persist box.When an alarm goes off, it sounds until you acknowledge thealarm message by pressing ENTER.Navigation (Nav) AlarmsNext Turn—sets an alarm to indicate the next turn in a route. SelectDist to enter a specific distance before you reach the next turn tosound the alarm. Select Time to enter a specific time before the turnfor the alarm to go off. Select Auto for the unit to provide a NextTurn alarm at its discretion.72 276C Plus Owner’s <strong>Manual</strong>190-00501-00_0A.indd 721/13/2005 10:43:51 AM
Arrival—sets an alarm to sound when you are a specified distanceor time away from a destination waypoint. Select Auto for the unitto provide an Arrival alarm at its discretion.Off Course—sets an alarm to sound when off your desired course.Select On, then enter a distance.Anchor Drag—sets an alarm to sound when you have exceeded aspecified drift distance. Select On and then enter a distance.Sonar AlarmsADDITIONAL FEATURES > SETTING ALARMSSystem AlarmsClock—sets an alarm based on the unit’s clock. Select On and thenenter the specific time that you want the alarm to sound. The unitmust be on for the clock alarm to work.Ext. (External) Voltage—sets an alarm to sound when the externalvoltage drops below a specified amount. Select On and then enter aspecific voltage.DGPS—sets an alarm to sound when the unit loses a differential fix.Accuracy—sets an alarm to sound when GPS accuracy falls outsideof the user-set value. Select On and then enter a specific distance.Sonar Alarms TabShallow Water/Deep Water—sets an alarm to sound when youenter an area of water that is too shallow or deep. Select On andthen enter a specific depth. You must be receiving sonar NMEA datafor this function to work.Water Temp—sets an alarm to indicate if the water temperature hasexceeded or dropped below a specific temperature, or fallen outside/inside a specific temperature range. Select Above or Below and thenenter a specific temperature, or select Inside or Outside and enter arange of temperatures. You must be receiving sonar NMEA data forthis function to work.Drift—sets an alarm to sound when you have exceeded a specifieddrift distance. Select On and then enter a specific distance.Fish—sets an alarm to sound when fish are detected with sonar.276C Plus Owner’s <strong>Manual</strong> 73190-00501-00_0A.indd 731/13/2005 10:43:52 AM
Page 4 and 5:
INTRODUCTION > TABLE OF CONTENTSTab
Page 6 and 7:
INTRODUCTION > TABLE OF CONTENTSUsi
Page 8 and 9:
INTRODUCTION > TABLE OF CONTENTSApp
Page 10:
GETTING STARTED > CHARGING THE 276C
Page 13 and 14:
GETTING STARTED > GETTING SATELLITE
Page 15 and 16:
Learning about the KeypadPress the
Page 17 and 18:
GETTING STARTED > USING THE 276C PL
Page 19 and 20:
Simulated Basic NavigationTo help y
Page 24 and 25:
BASIC OPERATION > FINDING AN ITEMUs
Page 26 and 27:
BASIC OPERATION > CREATING AND USIN
Page 28 and 29:
BASIC OPERATION > CREATING AND USIN
Page 30 and 31: BASIC OPERATION > CREATING AND USIN
Page 34: BASIC OPERATION > CREATING AND USIN
Page 40 and 41: BASIC OPERATION > MANAGING YOUR TRA
Page 42 and 43: BASIC OPERATION > MANAGING YOUR TRA
Page 44 and 45: BASIC OPERATION IN THE SEA MODES >
Page 50 and 51: SEA MODES PAGES AND FEATURES > MAP
Page 52 and 53: SEA MODES PAGES AND FEATURES > MAP
Page 54 and 55: SEA MODES PAGES AND FEATURES > COMP
Page 56 and 57: SEA MODES PAGES AND FEATURES > HIGH
Page 58 and 59: SEA MODES PAGES AND FEATURES > ACTI
Page 60 and 61: SEA MODES PAGES AND FEATURES > TIDE
Page 62 and 63: SEA MODES PAGES AND FEATURES > ENTE
Page 64 and 65: SEA MODES PAGES AND FEATURES > VIEW
Page 66 and 67: SEA MODES PAGES AND FEATURES > USIN
Page 68 and 69: SEA MODES PAGES AND FEATURES > USIN
Page 70 and 71: BASIC OPERATION IN THE LAND MODES >
Page 76 and 77: PAGES AND FEATURES OF THE LAND MODE
Page 78 and 79: PAGES AND FEATURES OF THE LAND MODE
Page 82 and 83: ADDITIONAL FEATURES > USING THE CAL
Page 84 and 85: ADDITIONAL FEATURES > VIEWING CELES
Page 86 and 87: ADDITIONAL FEATURES > VIEWING THE T
Page 88 and 89: CUSTOMIZING YOUR 276C PLUS > SETTIN
Page 96 and 97: CUSTOMIZING YOUR 276C PLUS > CUSTOM
Page 98 and 99: CUSTOMIZING YOUR 276C PLUS > CHANGI
Page 100 and 101: CUSTOMIZING YOUR 276C PLUS > CHANGI
Page 102 and 103: SETTING UP AND USING SONAR > USING
Page 108 and 109: SETTING UP AND USING SONAR > SETTIN
Page 110 and 111: SETTING UP AND USING SONAR > SETTIN
Page 112 and 113: SETTING UP AND USING SONAR > UNDERS
Page 114 and 115: APPENDIX > SPECIFICATIONSSpecificat
Page 116 and 117: APPENDIX > OPTIONAL ACCESSORIESOpti
Page 118 and 119: APPENDIX > INSTALLATION INFORMATION
Page 120 and 121: APPENDIX > INSTALLATION INFORMATION
Page 122 and 123: APPENDIX > LEARNING ABOUT GPS• Us
Page 124 and 125: APPENDIX > LORAN TD SETUPTo set up
Page 126 and 127: APPENDIX > DIGITAL SELECTIVE CALLIN
Page 128 and 129: APPENDIX > DATA FIELD OPTIONSData F
Page 130 and 131:
APPENDIX > MESSAGESMessagesApproach
Page 132 and 133:
APPENDIX > SAFETY AND PRODUCT INFOR
Page 134 and 135:
APPENDIX > SAFETY AND PRODUCT INFOR
Page 136 and 137:
INDEXDigital Selective Calling. See
Page 138 and 139:
INDEXSerial Number 1, 123Setup TabC
Page 140:
For the latest free software update
show all

Owner's Manual - West Marine

Create successful ePaper yourself

Delete template?

Save as template?