CDK-111A-Lite Owner's Guide - Ross Video

More documents

Recommendations

Info

About This GuideThis guide covers the installation and operation of the Ross Video CDK-111A-Lite,Component Digital Keyer.Along with a Table of Contents, the following chapters are included:• Chapter 1, “Introduction” summarizes the guide and describes thecomponents and features of the CDK-111A-Lite.• Chapter 2, “Installation and Setup” provides basic installationinstructions for each module, including cabling, jumper settings, andcommunication configuration.• Chapter 3, “Operation” provides a detailed chart of all card-levelfunctions, plus comprehensive information on all operating modes,menus, and features.• Appendix A, “Serial Protocol” outlines the communication protocolsused by the CDK-111A-Lite.• Appendix B, “Software Upgrades” provides detailed instructions onhow to perform software upgrades.• Appendix C, “Specifications” outlines the module specifications.An Index is also provided for your reference.Should you have a question pertaining to the operation of your CDK-111A-Lite,please contact us at the numbers listed in the front of this guide. Our technicalsupport staff is always available for consultation, training, or service.1-2 • Introduction CDK-111A-Lite • Owner’s Guide v4B
Documentation ConventionsThe following conventions are used throughout this guide:• Rear panel connectors and card-level components are indicated in boldfacedupper case letters. For example:The NTSC/PAL OUT 1 connector is …• Menu functions on the Preview Overlay are indicated in bold-facedupper and lower case text. For example:The NTSC Setup Function allows you to …• Menu choices on the Preview Overlay are indicated in bold-faced uppercase letters, using sans-serf font. For example:Select BANK A to access the first bank of …CDK-111A-Lite • Owner’s Guide v4B Introduction • 1-3
Page 1 and 2: Ross Video LimitedCDK-111A-LiteOwne
Page 4 and 5: Important Regulatory and Safety Not
Page 6 and 7: Company AddressRoss Video Limited R
Page 9 and 10: ContentsIntroduction 1-1A Word of T
Page 11 and 12: Technical Specifications...........
Page 13: IntroductionA Word of ThanksCongrat
Page 17 and 18: AbbreviationsThe following abbrevia
Page 19 and 20: Product Comparison ChartFor your re
Page 21 and 22: A Word about Technical SupportAt Ro
Page 23 and 24: Installation and SetupIn This Chapt
Page 25 and 26: OverviewCDK 11111023456798CDK111A-L
Page 27 and 28: BNC ConnectorsThis section defines
Page 29 and 30: Single CDK-111A-Lite Settings for R
Page 31 and 32: Accessing the Menu SystemSetup and
Page 33 and 34: Control Panel - DCP-111 (Optional)U
Page 35 and 36: Navigating Through the Menus Using
Page 37 and 38: The next series allow you to config
Page 39 and 40: 8012345 67Card Address Configuratio
Page 41 and 42: OperationIn This ChapterThis chapte
Page 43 and 44: 4) Menu Select/FTB Button (SW4)•
Page 45 and 46: Control Panel - DCP-111 (Optional)T
Page 47 and 48: GPIs and TalliesThis section descri
Page 49 and 50: The Menu SystemThe CDK-111A-Lite is
Page 51 and 52: Menu 1: Runtime ParametersAuto Tran
Page 53 and 54: Menu 4: Box Mask PositioningMenu 4:
Page 55 and 56: Menu A: DiagnosticsMenu A: Diagnost
Page 57 and 58: Menu D: Card SetupTest PatternSelec
Page 59 and 60: Menu F: BNC ListingMenu F: BNC List
Page 61 and 62: Appendix A. Serial ProtocolsIn This
Page 63 and 64: By means of “read” and “write
Page 65 and 66:
The components of the serial data a
Page 67 and 68:
Receive commandfrom editorMake chan
Page 69 and 70:
Message BytesThe number of message
Page 71 and 72:
Protocol Command DescriptionsList o
Page 73 and 74:
Bit776655Analog Control Command (45
Page 75 and 76:
NotePush-button / Lamp Control Comm
Page 77 and 78:
Transition Mode Command (4A, CA)Fun
Page 79 and 80:
Rate2=Next most significant digitRa
Page 81 and 82:
Software Version Command (6C, EC)Th
Page 83 and 84:
Error Status Command (71, 72)The ed
Page 85 and 86:
GVG MASTER2100 Emulation ProtocolTh
Page 87 and 88:
Command ListThe following table lis
Page 89 and 90:
Select Transition Type (0x03, TX_TY
Page 91 and 92:
FunctionCrosspoint byte values:00 N
Page 93 and 94:
Key Enable (0x0B, KEY_ENABLE)Functi
Page 95 and 96:
FunctionQUERYErrorCodeFunctionQUERY
Page 97 and 98:
either end of the communications li
Page 99 and 100:
Appendix B. Software UpgradesIn Thi
Page 101 and 102:
CautionCard may be hot to the touch
Page 103 and 104:
Appendix C. SpecificationsIn This A
Page 105 and 106:
Feature Comparison ChartFeature CDK
Page 107 and 108:
CDK-111A-Lite BNC SettingsConnector
Page 109 and 110:
I/O, Power, Delay SpecificationsTec
Page 111 and 112:
BNC 4 (Tx) RS422/RS485 Jumper Confi
Page 113 and 114:
Index112-Bit Analog Value..........
Page 115 and 116:
GPIabbreviation ...................
Page 117 and 118:
SW5, Board ID Switch ..............
show all

CDK-111A-Lite Owner's Guide - Ross Video

Create successful ePaper yourself

Delete template?

Save as template?