CDK-111A-Lite Owner's Guide - Ross Video

Menu E: Tally / GPI SetupMenu E: Tally / GPI SetupGPI #1 (BNC 2) GPI Function for GPI #1. This is only used if BNC 2 is set to GPI #1 in Menu D: CardSetup and jumper J6 is bridged at pins 1 and 2.• USED FOR COMM (default setting)• USED FOR TALLY• AUTO FTB• AUTO KEY 1• CUT KEY 1GPI #1 Trigger GPI Trigger for GPI #1.• EDGE HIGH (default setting)• EDGE LOW• LEVEL HIGH• LEVEL LOWGPI #2 (BNC 3) GPI Function for GPI #2. This is only used if BNC 3 is set to GPI #2 in Menu D: CardSetup. See GPI #1 list for options available here. (same default settings as BNC 2)GPI #2 Trigger GPI Trigger for GPI #2. See GPI #1 Trigger options. (same default settings as BNC 2)GPI #3 (BNC 3) GPI Function for GPI #3. This is only used if BNC 4 is set to GPI #3 in Menu D: CardSetup. See GPI #1 list for options available here. (same default settings as BNC 2)GPI #3 Trigger GPI Trigger for GPI #3. See GPI #1 Trigger options. (same default settings as BNC 2)Tally #1 (BNC 2) Tally Function for Tally #1: This is only used if BNC 2 is set to TALLY #1 in Menu D:Card Setup and jumper J6 is bridged at pins 5 and 6.• USED FOR COMM (default setting)• USED FOR GPI• KEY 1Tally #1 Trigger Tally Trigger for Tally #1.• LEVEL HIGH (default setting)• LEVEL LOWTally #2 (BNC 3) Tally Function for Tally #2: This is only used if BNC 3 is set to TALLY #2 in Menu D:Card Setup. See Tally #1 list for options available here. (same default settings as BNC 2)Tally #2 Trigger Tally Trigger for Tally #2.• LEVEL HIGH (default setting)• LEVEL LOWTally #3 (BNC 4) Tally Function for Tally #3: This is only used if BNC 4 is set to TALLY #3 in Menu D:Card Setup. See Tally #1 list for options available here. (same default settings as BNC 2)Tally #3 Trigger Tally Trigger for Tally #3.• LEVEL HIGH (default setting)• LEVEL LOW3-18 • Operation CDK-111A-Lite • Owner’s Guide v4B