CDK-111A-Lite Owner's Guide - Ross Video

OverviewCDK 11111023456798CDK111A-Lite Card, Component Side1) USB Port (Not Implemented) 5) Menu Select / FTB Button 9) GPI, Panel, Tally Jumper Block2) Menu Selector 6) Board ID Switch 10) RX Termination Jumper Block3) Menu Up Button 7) Reset Button and Download Connector4) Menu Down / Key Button 8) EDH Insertion Jumper Block1) USB Port (J2)Not implemented.2) Menu Selector (SW1)The Menu Selector is a 16 position rotary knob, labeled 0 to F. It isused to select the various menus for card installation and operation.3) Menu Up Button (SW2)Menu mode – this button moves the cursor to the item above on themenu. A momentary press will advance one item. When an item isselected, holding the button will scroll up through the possible values.4) Menu Down / Key Button (SW3)Operation mode – this button will dissolve a key on or off. It uses thetransition rate set in the menu.Menu mode – this button moves the cursor to the item below on themenu. A momentary press will advance one item. When an item isselected, holding the button will scroll up through the possible values.5) Menu Select / FTB Button (SW4)Operation mode – this button fades the PGM output to black or bringsthe PGM up from black, depending upon its present state. It uses thetransition rate set in the menu.Menu mode – this button moves the cursor to the sub-menu values inthe right-hand column. The values in these sub-items can then beadjusted using the Menu Up or Menu Down button. Pressing theMenu Select button again will return the cursor to the left-handcolumn.CDK-111A-Lite • Owner’s Guide v4B Installation and Setup • 2-3