CDK-111A-Lite Owner's Guide - Ross Video

Control Panel – DCP-111 (Optional)The optional Control Panel is used to configure and/or operate a single CDK-111A-Lite. It isconnected to BNC 2 on the rear of the CDK-111A-Lite. The Control Panel replicates thecapabilities and functionality of the card edge controls.NoteWhen using a Control Panel, ensure that the GPI, Panel, TallyJumper (J6) is bridged at pins 3 and 4 on the jumper and BNC2 is set in Menu D: Card Setup to Control Panel. SeeAppendix C, “Specifications” and the silk screening on theback of the CDK-111A-Lite card for jumper setting reference.Caution — Only one bridge may be installed on the jumperblock J6. Installing more than one bridge may causepermanent damage to the CDK-111A-Lite card. Please notethat contrary to the other jumper blocks, the single bridge onJ6 must be installed horizontally across either pins 1 and 2, orpins 3 and 4, or pins 5 and 6.CDKD IGITALM IXERK EYERERR101MENUTRANS R ATESLOWFASTADJFADETOBLACK324A B6 8KEY1 KEY2ON ON ON ONMENU +AUTOITEM +AUTOAUTOMENU -CUTITEM -CUTSELECTCUT9B KGD EXTERNAL I NTERNAL5 71) Menu Button 5) BKGD Cut Button 9) Key 2 Cut Button2) Trans Rate Toggle Switch 6) Key 1 Auto Trans Button 10) Secret Till Lit Error LED3) Fade To Black Button 7) Key 1 Cut Button4) BKGD Auto Trans Button 8) Key 2 Auto Trans ButtonCDK-111A-Lite • Owner’s Guide v4B Operation • 3-5