CDK-111A-Lite Owner's Guide - Ross Video

Select Transition Type (0x03, TX_TYPE)Select the Transition Type for the next transition. The CDK-111A-Lite does notsupport wipes. If a wipe transition is selected , the CDK will perform a fade. If atransition type has been configured as a custom transition, the transition will executeas a custom transition.Select Transition Type (0x03, TX_TYPE)FunctionCOMMANDQUERYREPLYCommand Data FieldTransition1 byte1 byteTransition data byte values:01 Take02 Fade-Fade03 Take-Fade04 Mix05 Fade-Take06 Wipe (only does fade)Select Transition Rate (0x04, TX_RATE)Command information:• Replies: returns the rate type and rate value for the next transition.• If a new Transition Type is selected by the Automation system, anypreviously specified protocol rate will be overridden by the rate associatedwith the selected Transition Type. Therefore the automation system mustfirst send the desired Transition Type, then send the Rate.• If a Rate is selected, it is “remembered” as associated with the currentlyselected (non-Cut Transition Type. Whenever that Transition Type is againselected, the remembered Rate is recalled (Slow, Medium, Fast).• When automation selects a = Slow, Medium, or Fast, it isremembered.• When automation selects a = Rate and supplies a value, thevalue will not be remembered for the current Transition Type.FunctionSelect Transition Rate (0x04, TX_RATE)Command Data FieldsRate typeRateCOMMAND 1 byte 1-2 bytesQUERYREPLY 1 byte 1-2 bytesCDK-111A-Lite • Owner’s Guide v4B Appendix A. Serial Protocols • 4-29