CDK-111A-Lite Owner's Guide - Ross Video

Menu D: Card SetupTest PatternSelectionDisplay Test PatternBNC 2BNC 3BNC 4Factory DefaultThis allows you to choose from the following built in test patterns, which the card willoutput when you have Display Test Pattern set to ON.• COLOR BARS 75% (default setting)• FLATFIELD BLACK• PLL PATHOLOGICAL• EQ PATHOLOGICALON/OFF. Press Select button to view test pattern.BNC 2 can be configured in one of three ways – either as the I/O for the control panel, aninput for a GPI, or as a Tally output. To configure BNC 2 as a:• CONTROL PANEL – When selected, bridge jumper J6 (see card diagram at thebeginning of Chapter 2, “Installation and Setup”, for the location of J6) on the card atpins 3 and 4. See Appendix C, “Specifications” for jumper pinout reference. (defaultsetting)• GPI # – When selected, bridge jumper J6 (see card diagram at the beginning of Chapter2, “Installation and Setup”, for the location of J6) at pins 1 and 2. See Appendix C,“Specifications” for jumper pinout reference.• TALLY # – When selected, bridge jumper J6 (see card diagram at the beginning ofChapter 2, “Installation and Setup”, for the location of J6) on the card at pins 5 and 6.See Appendix C, “Specifications” for jumper pinout reference.BNC 3 can be configured in one of three ways – either as an RX input, a GPI input, or asa Tally output. To configure BNC 3 as an,• COMM RX – If GVG100 or Master2100 protocol is selected above, BNC 3 must be setto this option. (default setting)• GPI #2 – Uses BNC 3 as GPI #2.• TALLY #2 – Uses BNC 3 as Tally #2.NOTE: If BNC 3 is configured as an RX input, ensure that BNC 4 is set to thecorresponding TX configuration.BNC 4 can be configured in one of three ways – either as a TX output, a GPI input, or asa Tally output. To configure BNC 4 as a,• COMM TX – If GVG100 or Master2100 protocol is selected above, BNC 4 must be setto COMM TX. (default setting)• GPI #3 – Uses BNC 4 for GPI #3.• TALLY #3 – Uses BNC 4 for Tally #3.Selecting the Factory Default will reset all values on the card to the initial factory defaultsettings and reset the card itself.CDK-111A-Lite • Owner’s Guide v4B Operation • 3-17