4 Burner4 Burner4.1 Burner selectionFor the <strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong>, <strong>SB615</strong> and <strong>SB745</strong> floorstanding gas condensing boilers, matching pressure-jetgas burners are required. They must be approved toEN 676 and bear the CE mark. Either 2-stage ormodulating pressure-jet gas burners can be considered.For preference, modulating burners should be used. Aminimum burner load is not required.For <strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong>, <strong>SB615</strong> and <strong>SB745</strong> floorstanding oil condensing boilers, type-tested oil burners toEN 267 can be used if they are approved by themanufacturer for low sulphur fuel oil EL to DIN 51603-1(sulphur content < 50 ppm) and for fuel oil EL A Bio10 toDIN 51603-6, and if their operating range correlates withthe boiler specification.When selecting a burner, it must be ensured that thepressure drop on the hot gas side is reliably overcome.When positive pressure at the flue outlet is required(sizing of the flue system), this must be taken intoconsideration in addition to the pressure drop on the hotgas side.To simplify planning and facilitate installation, the<strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong> VM and <strong>SB615</strong> VM floor standinggas condensing boilers (up to 310 kW) are available asUnit versions with modulating premix gas burners of theLogatop VM type, and the <strong>SB315</strong> oil/gas (up to 70 kW)as a Unit version with the Logatop BE-A blue flame oilburner from <strong>Buderus</strong>. Furthermore, the <strong>Logano</strong> <strong>plus</strong> <strong>SB615</strong>and <strong>SB745</strong> floor standing gas condensing boilers areavailable with matching pressure-jet gas burners from theWeishaupt and Riello brands. The standard deliveryincludes the boiler, burner and drilled burner plate. Withthe versions without a burner, a drilled or non-drilledburner plate must be ordered separately.For further details regarding burners andassociated burner plates, see the current<strong>Buderus</strong> catalogue.4.2 Modulating Logatop VM gas premixburner4.2.1 Equipment overviewThe <strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong> VM floor standing gascondensing boilers are supplied as standard as the Unitversion with matching modulating Logatop VM2.0 and3.0 premix gas burners ( fig. 23, page 31), and the<strong>Logano</strong> <strong>plus</strong> <strong>SB615</strong> VM floor standing gas condensingboilers up to boiler size 310 with the Logatop VM4.0 and5.0 ( fig. 24, page 31) from <strong>Buderus</strong>.All Unit versions with Logatop VM are characterised byfactory matching and testing of the burners at operatingtemperature. Precisely matching the burner output to theboiler size results in high levels of efficiency and lowpollutant and sound emissions. The compact design andlow weight of the Logatop VM burners enables easyhandling.The central component of all Logatop VM is the metalfibre burner rod. In the mixing zone of this rod, thecombustion air and fuel gas undergo optimal premixingand are then distributed evenly over the surface. The largeflame surface area and even distribution of the mixturecause combustion to begin smoothly at low temperaturesand with low NO x emissions. As a result of modulatingoperation, the noise level is so low that the Logatop VMburner is practically inaudible even without the burnerhood, particularly in partial load operation. Additionalsound insulation measures are usually unnecessary.The Logatop VM premix gas burner is fitted as standard tothe boiler door, which can be pivoted open formaintenance. All components that are important forcorrect function are easily accessible for service work.The burner control unit of the burner shows currentoperating and service conditions.The burner door can pivot either to the left or right.However, the opening direction is limited to only one sideby the gas line or gas train. The selection of a suitableburner for the specific project can be discussed in detailwith the <strong>Buderus</strong> sales office ( back cover).For the pressure-jet oil and gas burners in theUnit version, the quotation includescommissioning and adjustment as well ascommissioning optimisation as extras.30Technical guide Floor standing gas/oil condensing boilers <strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong>, <strong>SB615</strong>, <strong>SB745</strong> – 6 720 802 589 (2012/01)
Burner44.2.2 Logatop VM2.0 and 3.0 for<strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong> VMThe Logatop VM2.0/3.0 has electrical ignition and flamemonitoring. The gas is supplied evenly via two gas combivalves and a gas pressure switch, and is possible from theleft or right. All important parameters are factory-set tonatural gas E; subsequent adjustments are not necessary(plug and burn). The Logatop VM2.0/3.0 is suitable fornatural gas E, LL and LPG. For information on convertingto other gas types, see page 33.124.2.3 Logatop VM4.0 and 5.0 for<strong>Logano</strong> <strong>plus</strong> <strong>SB615</strong> VM (up to 310 kW)The Logatop VM4.0/5.0 has electrical ignition and flamemonitoring. The gas is supplied via a gas combi valve onthe left hand side of the burner. The gas combi valvecontains a double solenoid valve with continuoustightness test integrated as standard. All importantparameters are factory-set to natural gas E; subsequentadjustments are not necessary (plug and burn). TheLogatop VM4.0/5.0 is suitable for natural gas E and LL.For information on converting to other gas types, seepage 33.51342Fig. 23566 720 642 881-22.1ilStructure of the Logatop VM2.0/3.0 premix gasburner from <strong>Buderus</strong>1 Door hinge (on the left or right)2 Gas pressure switch3 Gas combi valve4 Fan with internal motor5 Gas connection (Rp1) (on the left or right)6 Burner rod with metal fibre surfaceFig. 243Structure of the Logatop VM4.0/5.0 premix gasburner from <strong>Buderus</strong>1 Digital burner control unit2 Gas combi valve with integral tightness test3 Gas connection (Rp1½ or Rp2 for boiler size 310)4 Electronically controlled fan5 Door hinge46 720 642 881-23.1ilTechnical guide Floor standing gas/oil condensing boilers <strong>Logano</strong> <strong>plus</strong> <strong>SB315</strong>, <strong>SB615</strong>, <strong>SB745</strong> – 6 720 802 589 (2012/01) 31