ABB i-bus® EIB Switch/dim actuator, FM Type: 6114 U-500

ABB i-bus ® EIBSwitch/dim actuator, FMType: 6114 U-500 + 6325-xxIR LCD Switch Dim Shutter /3Selection in ETS2– ABBPush Button tritonPush button, 5-fold for 1SDAThe application program is intendedfor the 5-fold Busch-triton ® switchsensor application module with displayin connection with a switch/dimactuator FM.The Busch-triton ® switch sensor can beused for switching, dimming andshutter control.Rockers 1, 2, 4 and 5 of the Buschtriton® switch sensor each have thesame set of parameters. With theparameter “Operation mode of rocker”,the basic switching, dimming andshutter control functions can beselected. Depending on this setting,different parameters and objects areavailable for the rockers. There is acommon parameter “Push buttonaction interpreted as long from” for allthe rockers that are used for dimmingor shutter control. Normally, the switchsensor detects a long push buttonaction if a rocker is pressed for longerthan 420 ms.BacklightingThe backlit text fields display thefunctions of the rockers even in thedark. Using the communication object“Backlighting/LED”, the backlightingand status LEDs can be switched on oroff if required.The auxiliary push button can also beused for manual switching. To do so,the parameter “Function of auxiliarypush button” must be set to“Backlighting and LED on/off”. Whenthe auxiliary push button is pressed,not only is the lighting of the switchsensor switched on or off but atelegram is sent via the communicationobject “Backlighting/LED”. It istherefore possible to switch on thelighting for several Busch-triton ® switchsensors at the same time via acommon group address.By default, the backlighting switcheson after bus voltage recovery. This canalso be changed via the parameter“Behaviour of backlighting at busrecovery”.Fault protectionThe auxiliary push button also makesthe fault protection function available.The fault protection function causesonly one basic function to be triggeredwhen any of the rockers of the switchsensor are pressed. For example,pressing one of the five rockers viacommunication object no. 1 “Faultprotection” switches the base lightingalternately on or off.The fault protection function can bepermanently activated or for examplebe timed to switch on or off via the EIBusing object no. 0 “Fault protection Off/On”. If the parameter “Function ofauxiliary push button” is set to“Interrupt fault protection”, the rockerscan be used for different functionsaccording to their parameter settingsafter pressing the auxiliary push buttonfor approx. 5 seconds.Dimmer outputThe output of the dimming actuator/sensor is linked internally to rocker 3via objects no. 7 and 8. It can thereforebe operated via rocker 3 without anyfurther local connection. If the outputshould also be controlled via the bus,communication objects no. 7 “Output,Telegr. switch / switch” and no. 8“Dimmer, Telegr. dimming / rel.dimming” can be linked with theobjects of the other switch sensor.Object no. 9 “Dimmer, Brightnessvalue” enables the integration of theoutput into lightscene control.IRIn addition to using the rockers, theBusch-triton ® switch sensor can alsobe controlled remotely via an infraredhand-held transmitter. The five rockersand the auxiliary push button can beassigned to the white or blue infraredarea of the hand-held transmitter. Therelevant setting must then be selectedvia the slide switch on the transmitter.The MEMO button of the transmittercorresponds to the function of theauxiliary push button of the Buschtriton® switch sensor.8 - 138 March 2003