ABB i-bus® EIB Switch/dim actuator, FM Type: 6114 U-500

ABB i-bus ® EIBSwitch/dim actuator, FMType: 6114 U-500 + 6325-xx4. The rockers that are not used forlightscenes are still available forswitching, dimming or shutter control.The parameter value “no function /display operation” must be selectedfor unassigned rockers.If a rocker is used for recallinglightscenes, the LED indicates whichside of the rocker has been pressed. Itglows red when the left side is pressedand glows green when the right side ispressed. If several rockers are used,the LED of the rocker which was lastpressed lights up.Application example:A dimmable lamp is installed in a hotelroom in the sleeping area togetherwith a dimmable lamp in the entrance.There is also a reading light by thebed. The room can be darkened withan electrically driven blind. The light inthe adjoining bathroom can also bedimmed.From the door, it should be possible tooperate the dimmable lamps in thesleeping area and entrance togetherbut operate the light in the bathroomseparately. It should also be possibleto operate the blind.Two lightscenes can be recalled via apush button action:1.Switch all the lights to almostmaximum brightness and raise theblind to clean the room.2.Switch off all the lights and raise theblind when leaving the room.From the bed, it should be possible toswitch the lights in the sleeping areaand entrance together but dim thereading light separately. It should alsobe possible to operate the blind.Two lightscenes should be recalled viaa push button action:1.Dim the lights in the bathroom andentrance to semi-brightness to lightthe way during the night and switchoff the reading light.2.Switch off all the lights for sleeping.Two 5-fold Busch-triton ® switchsensors are used, each with adimming actuator/sensor FM togetherwith two switch/dim actuators and ashutter actuator.The Busch-triton ® switch sensor at thedoor has the following parametersettings:Number of lightscenes:2Lightscenes are available on:Rocker 5Function of auxiliary push button:no function / display operationOperation mode of rocker 1:Dimming sensorOperation mode of rocker 2:Dimming sensorOperation mode of rocker 3:Dimming sensorOperation mode of rocker 4:Shutter sensorOperation mode of rocker 5:Rocker is assigned to twolightscenesRocker is assigned to IR push button:no IRType of actuator group A:Dimming actuator (8 bit)Type of actuator group B:Dimming actuator (8 bit)Type of actuator group C:Dimming actuator (8 bit)Type of actuator group D:Dimming actuator (8 bit)Type of actuator group E:Switch or shutter actuator (1 bit)The two lightscenes are defined asfollows:Lightscene 1: Base lightingActuator group A: 80%,Actuator group B: 80%,Actuator group C: 80%,Actuator group D: 80%,Actuator group E: UPLightscene 2: OFFActuator group A: 0%,Actuator group B: 0%,Actuator group C: 0%,Actuator group D: 0%,Actuator group E: UPThe 1 bit and 4 bit communicationobjects of rockers 1 and 2 are linked tothe corresponding objects of theactuators for the luminaires in theentance area and sleeping area.The two objects of rocker 3 are linkedto the objects of the dimming actuator/sensor.The transmit flags are set for theswitching objects of the dimmingactuators. The status LEDs can also becontrolled when the lightscenes arerecalled.March 2003 8 - 147